hansgrohe 14061XXX Metropol S Geometric Taps for Modern Bathrooms Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
- hansgrohe 14061XXX Metropol S Geometric Taps for Modern Bathrooms
- Product Information
- Assembly
- Safety Notes
- Assembly Instructions
- Installation Instructions
- Technical Data
- Spare parts
- Special accessories
- operation
- Test certificate
- CONTACT
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
hansgrohe 14061XXX Metropol S Geometric Taps for Modern Bathrooms
Product Information
The product is a shower system with a single-lever mixer and a hot water limiter. It has a maximum operating pressure of 1 MPa and a recommended operating pressure of 1.6 MPa. The hot water temperature can be adjusted using the hot water limiter on the mixer, and a continuous flow water heater can be used without the need for a warm water shut-off valve. The shower system should only be used for bathing, hygiene, and body cleansing purposes.
Assembly
Technical
Specifications
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 1.6 MPa
- Hot water temperature: adjustable with hot water limiter
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting injuries. The hot and cold supplies must be of equal pressure to avoid any accidents.
Assembly Instructions
The installation kit is not included in the package and must be purchased separately. Follow the assembly instructions provided on page 31 of the user manual. Adjust the hot water limiter on the mixer as per the instructions on page 33. Do not use silicone containing acetic acid. Refer to the enclosed brochure for cleaning instructions.
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The shower system may only be used for bathing,
- hygienic and body cleansing purposes.
- The hot and cold supplies must be of equal pressures.
Installation Instructions
- The fitting must be installed, flushed and tested after the valid norms.
- If the instantaneous water heater causes problems or
- if you wish to increase the water flow, the EcoSmart® (flow limiter) located behind the aerator can be removed.
Technical Data
This mixer series-produced with EcoSmart® (flow limiter)
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
- Hot water temperature: max. 80°C
- Recommended hot water temp.: 65°C
Hansgrohe mixers can be used together with hydraulically and thermally controlled continuous flow heaters if the flow pressure is at least 0,15 MPa.
Symbol Description
To adjust the hot water limiter on single lever mixers, 
No adjustment is necessary when using a continuous
flow water heater
Do not use silicone-containing acetic acid!
Dimensions 
Flow diagram
- with EcoSmart®
- without EcoSmart®
Spare parts
Special accessories
special tool (58085000) order as an extra
Installation kit order as an extra
operation
Cleaning
(see enclosed brochure)
Test certificate
CONTACT
- Hansgrohe ·
- Postfach 1145
- D-77761 Schiltach
- Telefon +49 (0) 78 36/51-1282
- Telefax +49 (0) 7836/511440 E-
- Mail: info@hansgrohe.com.
- Internet: www.hansgrohe.com.