MONI K401-3 Plastic Ride-on Car User Manual

User manual
Plastic ride-on car with parent control handle and canopy
Item No.: K401-3 Model: PARADISE

K401-3 Plastic Ride-on Car

IMPORTANT! READ CAREFULLY AND KEEP IT FOR FUTURE REFERENCE!
THE MANUAL CONTAINS IMPORTANT INFORMATION FOR ASSEMBLING, CORRECTLY USING, AND MAINTENANCE OF THE PRODUCT. THE TOY RESPONDS TO THE REQUIREMENTS OF EUROPEAN STANDARD EN 71-1-2-3.

PARTS

|
---|---

ASSEMBLY STEPS

WARNING

• Warning! It contains small parts. Suffocation hazard.
• You must be careful while you unpack and assemble the toy. Keep the children away from you, when you do these actions.
• Suffocation hazard! Keep the plastic packages away from children..
• Do not allow the child to take off the stickers if there are any over the product and to swallow them.
• The materials, which the product is made of, are suitable and safe for children’s health.

WARNINGS AND REFERENCES FOR SAFETY USAGE

1. Warning! To be used under the direct supervision of an adult.
2. This ride-on car is suitable for children aged 3-5 years, weighing up to 20 kg. The product cannot support the extra weight!
3. The toy is intended for use by one child only.
4. The assembly and installation should be performed by an adult. The product contains small or sharp and protruding parts.
5. Warning! During assembly, children should not be present. Choking hazard! Small parts.
6. The batteries must be handled by an adult only.
7. Not to be used in traffic.
8. Not to be used on steep slopes or near stairs, swimming pools or other water bodies. Use the product only on even grounds and safe areas.
9. Do not allow another child to push the ride-on car while your child uses it.
10. Check regularly the condition of each part. In case of damage, there is a risk of injuring your child.
11. Check regularly whether the nut and bolt on the steering wheel are fixed tightly and do not represent any danger.
12. If the product is not assembled properly this may lead to danger.
13. Do not allow the child to use the ride–on car barefoot.
14. The toy complies with Standard EN71 and meets the essential requirements for the “General safety of the product”.
15. Risk of suffocation. Remove all plastic packing immediately after unpacking the product.

HANDLING OF THE BATTERY

1. The battery should be handled by an adult only. Do not allow the children to play with the batteries.
2. Always remove the discharged batteries and do not throw them away with household waste, use the places designated for that purpose. They are recyclable.
3. Use АА batteries only.
4. Alkaline batteries are recommended.
5. Always remove the batteries, if you will not use the product for a long period of time.
6. When you replace the batteries always replace them with new ones, always replace all batteries. Children should not be present while you are replacing the batteries.
7. Do not mix old batteries with new ones.
8. Do not mix alkaline, standard (Carbon – Zinc), or rechargeable (Nickel – Cadmium) batteries.
9. Do not throw the batteries in the fire, because they may blow up or leak.

CLEANING AND MAINTENANCE OF THE PRODUCT

CLEANING

1. Regularly clean the product.
2. Do not use corrosive power cleaning agents or cleaning agents on alcoholic bases and those, containing abrasive particles.
3. Clean with a soft wet cloth. Always dry with a dry soft cloth after this.

MAINTENANCE AND STORAGE

1. Regularly check the product for broken or damaged parts. If you find any, do not use the product, until you remove the damage.

2. In case of damage, please contact the trade agent, which you bought the product from or the importer.

3. Do not repair by yourself! Do not make any modifications or changes to the product! This can threaten your child’s health.

4. Regularly check whether the main parts of the car are in good condition (steering wheel, main corpse, and wheels).

5. Keep the product from prolonged exposure to sunlight, as also from heating sources.

6. Storage in dry and windy places, away from direct heating sources – open fires, cooking ovens, and heating appliances.
   PARTS OF THE PRODUCT AND ASSEMBLING SCHEME– LOOK AT PAGE 1
   On the table are marked the following parts: 1. Car body; 2. Steering wheel;

7. Front fork; 4. Safety board; 5.Rear wheel holder;

8. Backrest; 7.Wheels; 8. Axle; 9. Parent control handle; 10.Canopy; 11.Footrests; 12. and 13. Bags with parts assist with the assembly.

INSTRUCTIONS FOR ASSEMBLING OF THE PRODUCT
Carefully read the instructions before starting to assemble the product. Follow exactly the separate steps of assembling and check after each action whether you have fixed the separate parts well. The schemes in this manual are only illustrative. The manufacturer keeps his right to change the way of assembling the product, without to notifying the customer in advance.

1. Step 1 – See figure 1 – Attaching the front wheels: Slide the front axle through the openings of the front fork. Attach one wheel to each side of the axle. Then put on each side bushing and cotter pin in order to fix the wheels. Attach the decorative plastic rims to the wheels.

2. Step 2 – See figure 2 –Attaching the rear wheels, steering wheel, and backrest:
   – Rear wheels: Attach the rear wheels holder to the car body. Fix it with 4 screws. Slide the rear axle through the openings in the holder. On each side of the axle place one wheel and then one gasket. Fix the wheels using the cotter pin and finish by placing the decorative rims.
   – Steering wheel: Slide the upper end of the front fork through the opening in the front car body. Place the steering wheel on top of the fork. Align the openings for the fixing screw on the steering wheel and steering fork. Slide 1 screw 5*40 and fix it using a nut and screwdriver.
   – Backrest: Place the backrest in the back part of the car body. Press carefully down until it is fixed. Place the 2 parts of the safety board on both sides of the backrest and steering wheel.

3. Step 3 – See figure 3 – Attaching the parent control handle and canopy: Slide the handle through the opening in the rear parts of the backrest and the car body. Finally, place the canopy.

REPLACEMENT OF THE BATTERIES

1. WARNING! Replacement of batteries should be performed in the absence of children!
2. The batteries are not included in the set.
3. Remove the screw of the lid of the battery compartment with a screwdriver and set it aside.
4. After that place 2 x AA 1.5 V batteries in the compartment, make sure that you observe the respective polarity (+/-) when you place them, it is indicated on the scheme “REPLACEMENT OF THE BATTERIES“ and also at the bottom of the compartment.
5. Replace the cover of the battery compartment and secure it with a screw.

Importer: Moni Trade LTD
Address: Bulgaria, city of Sofia, Trebich quarter, 1 Dolo str.
Tel: +359 2/ 936 07 90; Web:www.moni.bg

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>