NEXIGO EF60 ECR Touch POS Terminal User Guide
- June 14, 2024
- NEXIGO
Table of Contents
NEXIGO EF60 ECR Touch POS Terminal User Guide
Touch POS Terminal (Brief introduction)
**Unpacking
**
-
POS terminal
-
AC adapter
-
AC power cable
-
User’s manual
-
Roll paper
-
58mm paper stop
-
Foot pads
-
Card retrieval needle
Product introduction
Introduction to Side Interface and Serial Port Definition
- DC5V
- GND
- TXD
- RXD
**Bottom Interface
**
The descriptions and images involved are subject to the actual product in the box. This information is for reference only If there is any change, no notice will be given
Bank card reading and importing key
Insert the bank card with the chip facing upwards into the machine
Import keys through the TYPE-C port here
Printer Usage
-
Press the open cover key
-
Load paper roll
-
Close the cover-lid
58mm paper stop Usage
-
Press the open cover key
-
Place the 58mm paper stop at the far left corner of the paper bin
-
Close the cover-lid
Power on/off
- Thread the power plug from the bottom of the machine;
- Insert the output head of power adapter into the power port of the machine;
- Insert the other end of the adapter into the electrical socket for power supply;
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This device meets the government’s requirements for exposure to radio waves.
The guidelines
are based on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of scientific studies.
The standards include a substantial safety margin designed to assure the
safety of all persons regardless of age or health. FCC RF Exposure Information
and Statement the SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of
tissue.
Device types: Touch POS Terminal (FCC ID: XDQEF60-01) has also been
tested against this SAR limit. This device was tested for typical body-worn
operati ons with the back of the device kept 0mm from the body. To maintain
compliance with FCC RF exposure requirements, use accessories that maintain a
0mm separation distance between the user’s body and the back of the Touch POS
Terminal. The use of belt clips, holsters and similar accessories should not
contain metallic components in its assembly. The use of accessories that do
not satisfy these requirements may not comply with FCC RF exposure
requirements, and should be avoided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>