MONI HCY016 High Chair Bueno User Manual
- June 8, 2024
- MONI
Table of Contents
High Chair Bueno
User Manual
MANUAL OF HIGH CHAIR BUENO
Item No HCY016
HCY016 High Chair Bueno
This product is manufactured in accordance with the requirements of the Directive 2001/95 / EC “General Product Safety”, of the European Standards EN 14988: 2017+A1:2020 “Children’s high chairs – Requirements and test methods ” and the National Consumer Protection Act.
IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
WARNING!
- Never leave the child unattended.
- Always use the restraint system.
- Falling hazard: Prevent your child from climbing on the product.
- Do not use the product unless all components are correctly fitted and adjusted.
- Be aware of the risk of open fire and other sources of strong heat in the vicinity of the product.
- Be aware of the risk of tilting when your child can push its feet against a table or any other structure.
- Do not use the product until the child can sit up unaided.
- Do not use the product if any part is broken, torn or missing.
- Keep children away when unfolding and folding the product to avoid injury.
- The product is intended for children able to sit up unaided and up to 3 years or a maximum weight of 15 kg.
- Any additional harness other than the one provided by the manufacturer, shall comply with EN 13210.
- Always use the product on a stable, level surface.
- For high chairs equipped with more than two wheels on the legs, the parking device must always be activated when the product is used.
- Assembling, unfolding and folding the product must ONLY be done by an adult. Children should not be present during assembly, unfolding and folding of the product.
- Do not use the high chair without the tray and always make sure it is firmly mounted.
- Always provide enough, but safe, distance between the child and the tray.
- Be careful when adjusting the position of the tray, the footrest and when unfolding or folding the chair, as there is a risk of pinching your fingers.
- Use the tray always in combination with safety belts! The tray is not intended to protect the child from falling.
- Never lift, move, fold, adjust or repair the seat when there is a child in it. This can injure the child.
- Always before use, check the functioning of the locking mechanisms.
- Before placing the child in the seat, make sure that it is fully unfolded and locked in the open position and that all locking mechanisms are tightly closed! This will prevent the child from being injured by sudden folding of the chair.
ASSEMBLY AND EXPLOITATION
IMPORTANT! The diagrams and figures in this instruction are illustrative and indicative only. Check the securing of the fixation after each operation.
Components – illustrations A,B,C,D ,
А. Seat unit; B. Set of legs – 2 pieces (front and back feet); C. Two part
serving tray; D. Wheels – 4 pcs.
Assembly of the structure
WARNING! Make sure that the base is assembled correctly and is stable,
this ensures the safety of your child!
Strictly follow the instructions and sequence for assembling the product as
shown in the diagrams.
-
Press and hold the button shown in Figure 1 to open the frame all the way down.
-
Press the button shown in Figure 2 to remove and fix the tray.
-
Insert the front and rear legs into the respective pipes on the seat frame.
Press until you hear a clicking sound and the spring-loaded buttons tighten and come out of the holes provided for them (Figure 3). -
The tray can be adjusted in three positions. To adjust the position of the tray, pull the front lever from the underside of the tray and slide it along with the tray to the desired position (Figure 4).
Attention! Use the tray always in combination with safety belts! The tray is not intended to protect the child from falling. -
The five-point seat belt is designed to ensure the safety of your child and must be used at all times. To unfasten the belt, press the buckle button and pull out the fasteners. To fasten the belt, place the fasteners on the straps of the waist into the holes of the buckle and press until they lock. Sliding regulators are mounted on the straps and waist belt. The straps should be carefully adjusted to the child’s comfort (Figure 5).
-
The seat has 6 height adjustment levels (Figure 6). By pressing both side buttons on the frame at the same time, you move the seat down or up.
Caution! Do not change the height of the seat when a child is seated in the high chair. -
To adjust the backrest inclination, lift the plastic lever on the back of the seat and position the backrest in the desired position, release the mechanism to fix the backrest (Figure 7).
Caution! Do not change the inclination of the seat when a child is seated in the high chair. -
The footrest can be adjusted in 3 positions. To adjust it, press both side buttons shown in Figure 8 at the same time. In addition, the footrest has 3 positions according to the height of the child
-
Release the levers to the desired fixing position until a double click is heard, meaning that the tray is firmly locked (Figure 9). To adjust the position of the tray, pull the two levers at the same time.
-
Place the castors at the bottom of the legs as shown in Figure 10.
-
To lock the castors, use the locking mechanism placed on the castors themselves.
-
To fold the high chair, remove the tray and place it on the rear legs in the intended places. The backrest shall be fully erected and the seat shall be placed in the lowest position. Press both side buttons simultaneously and fold the seat (Figure 12).
INSTRUCTIONS FOR MAINTENANCE AND CLEANING
Clean only with a soft, dry cloth.
Regularly check fixed and moving parts for looseness, damage or breakage. Do
not repair the product yourself, but contact an authorized service center or
the sales agent from whom you purchased the product. Otherwise, your warranty
will be void. Periodically clean the product. Do not leave the product to the
harmful effects of external factors – direct sunlight, rain, snow or wind.
This can damage metal and plastic parts and bleach upholstery. Store the
product in a dry and ventilated place, not in dusty, damp rooms with very low
or very high room temperatures.
Manufactured for Moni in PRC
Manufacturer and Importer: Moni Trade Ltd.
Address: Bulgaria, Sofia, Trebich, 1 Dolo Str.,
Phone number: 003592/936 07 90
Website: :www.moni.bg
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>