maXpeedingrods Ford F-150 Rear Suspension Enhancement System Installation Guide

SUSPENSION KIT
INSTALLATION GUIDE
FIT FOR FORD
F-150 2WD 4WD
REAR SUSPENSION LEVELING KITABK- TF1501521-VLC

RUBBER KIT LIST

1| | 2X Rubber
spring φ95φ 2095
---|---|---
2| | 2X Spacer
3| | 2X Upper mounting bracket (Left and right)
4| | 2X Block
5| | 2X Lower mounting bracket
6| | 2X Hex bolt
M101.565-30
7| | 2X Hex bolt
M101.540-30
8| | 2X Hex bolt
M101.530
9| | 2X Gasket φ33φ
10.52
10| | 4X Flat
washer M10
11| | 2X Bushing
φ20φ10.515
12| | 2X Bushing
φ20φ10.525.5
13| | 2X Washer M10
14| | 4X Hex nylon nut M10*1.5
15| | 1X Car sticker

PRE-INSTALLATION NOTICE

• This product will not increase the load capacity of your vehicle.
• Do not exceed the manufacturer’s recommended weight limit.
• The installation process may require drilling, professional installation is recommended to ensure personal safety.
• All modifications must be installed by qualified personnel and in compliance with your local modification regulations.

INSTALLATION GUIDE

REMOVING THE BUMP STOP

STEP 1. Raise the vehicle with a jack and let the suspension kit assembly can be put into position between the axle and frame.
STEP 2. Remove the factory bump stop.

INSTALLING THE UPPER AND LOWER BRACKETS

STEP 1. Attach the upper mounting bracket( 3 of the Rubber kit list) to the frame.

STEP 2. Install the rubber spring(1 of the Rubber kit list) to the upper mounting bracket( 3 of the Rubber kit list) with washers and lock nuts.

NOTE: If necessary, you can use spacers to achieve the desired height.

STEP 3. Install the lower mounting bracket (10 of the Rubber kit list) with block (14 of the Rubber kit list) to the axle.

STEP 4. Repeat the same process on the other side.

INSTALLATION COMPLETED

WARNING
Cancer and Reproductive Harm
– www.P65Warnings.ca.gov

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>