maXpeedingrods ABK-TF2501723-VLC Rear Suspension Enhancement System Installation Guide

June 1, 2024
MAXPEEDINGRODS

maXpeedingrods-logo

maXpeedingrods ABK-TF2501723-VLC Rear Suspension Enhancement System

maXpeedingrods-ABK-TF2501723-VLC-Rear-Suspension-Enhancement-System-
product

PRE-INSTALLATION NOTICE

  • This product will not increase the load capacity of your vehicle.
  • Do not exceed the manufacturer’s recommended weight limit.
  • It is necessary to ensure that there is at least 1/2″ of gap between the kit and the frame when the car is empty.
  • All modifications must be installed by qualified personnel and in compliance with your local modification regulations.

INSTALLATION GUIDE

maXpeedingrods-ABK-TF2501723-VLC-Rear-Suspension-Enhancement-System-
fig-1

REMOVING THE BUMP STOP

  • STEP 1.
    • Raise the vehicle with a jack and make sure the suspension kit assembly can be put into position between the axle and frame.
  • STEP 2.maXpeedingrods-ABK-TF2501723-VLC-Rear-Suspension-Enhancement-System-fig-2
    • Remove the factory bump stop and keep the nuts.

INSTALLING THE RUBBER ASSEMBLY

  • STEP 1.maXpeedingrods-ABK-TF2501723-VLC-Rear-Suspension-Enhancement-System-fig-3
    • Install the rubber assembly to the frame with the bump stop nuts. Then insert the U-shaped gasket between the upper mounting bracket and the beam.
  • STEP 2.maXpeedingrods-ABK-TF2501723-VLC-Rear-Suspension-Enhancement-System-fig-4
    • Fasten all the nuts. Repeat the same process on the other side.

INSTALLATION COMPLETED

WARNING

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

MAXPEEDINGRODS User Manuals

Related Manuals