Maxpeedingrods LLK-CHE-7387-B-LC Notch Lowering Kit Compatible for Chevy Installation Guide
- June 1, 2024
- MAXPEEDINGRODS
Table of Contents
Maxpeedingrods LLK-CHE-7387-B-LC Notch Lowering Kit Compatible for Chevy
PRODUCT INFORMATION
C-notch is used for giving additional clearance when lowering the rear of your vehicle. It increases suspension travel on lowered vehicles. Note:The original frame must be cut to install this kit. This kit may not work for those vehicles equipped with air springs or coil-over kits. For those vehicles, extra modifications may be required.
KIT CONTENTS
INSTRUCTIONS
- Place the vehicle on level ground. Jack the vehicle and support it with jack stands.
- Mark on the vehicle frame where needs to be cut off. Use a grinder to cut off the frame.
- Put the new C-notch and drill new holes.
- Bolt the new c-notch on the frame and install the bump stop. Tighten all bolts and nuts down to spec.
- Repeat on the opposite side.
MAINTENANCE
- Highly suggest drivers inspect the nuts and bolts for tightness regularly.
- All modifications must be installed by qualified personnel and in compliance with your local modification regulations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>