maXpeedingrods LLK-JEP-0212-LC Lever Lift Kit Fits Jeep Liberty Instruction Manual
- June 1, 2024
- MAXPEEDINGRODS
Table of Contents
maXpeedingrods LLK-JEP-0212-LC Lever Lift Kit Fits Jeep Liberty Instruction Manual
PRODUCT INFORMATION
This leveling lift kit includes front spacers that bring a 2-inch lift to your front end. It improves the appearance of your pickup and maintains a comparable factory ride at the same time. Please note that the spacer thickness is not equal to the real lift height due to the suspension geometry.
KIT CONTENTS
2x Strut Spacers
8x Hexagon Flange Nuts Ml2*l.75
INSTRUCTIONS
01. Jack up the front end of the vehicle and support the axle with jack
stands. Remove wheels and tires.
02. Disconnect the upper control arm ball joint. Disconnect the sway bar end
link and tie rod.
03. Loosen the 4 nuts and bolts on the strut top. Loosen the strut bottom
nut. Take the strut out of the vehicle.
04. Install the strut spacer on the top of the strut. Install the strut
assembly back into the vehicle.
05. Reconnect the upper ball joint, sway bar end link, and tie rods. Tighten
all bolts down to spec.
06. Repeat steps 2-5 on the opposite side. Put tires and wheels on.
MAINTENANCE
A regular check of bolt tightness is highly required. We suggest drivers have
all bolts and nuts checked for tightness after the first 200 miles and then
every 1000 miles.
All modifications must be installed by qualified personnel and in compliance
with your local modification regulations.
LLK-JEP-0212-LC
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>