maXpeedingrods THR-RACLA3-LC Trailer Hitch Receiver Installation Guide
- June 1, 2024
- MAXPEEDINGRODS
Table of Contents
maXpeedingrods THR-RACLA3-LC Trailer Hitch Receiver
PRODUCTINFORMATION
This trailer hitch receiver is a bolt-on hitch that can be installed on your RAM 1500 without modification.
1|
| l x 2″ Hitch Receiver
---|---|---
2|
| l x Bracket with nut
3|
| 3x Spacer
4|
| 3 x Spring Pad
5|
| l x Hexagonal Screw
6|
| 2xScrew
INSTRUCTIONS
- Remove the centre cap from the rear bumper and insert the spacer(3), spring pad(4) and hexagonal screw(5) in sequence.
- Insert the bracket with nut (2) into the hole of the original rear reinforcement bar, with the side with the nut facing down.
- Install the 2″ trailer receiver (1) under the bracket with nut and tighten the hexagonal screw (5) by hand to secure the receiver.
- Use the screw (6) to connect the spring pad (4) and washer (3) to the bracket with nut.
- Finally, tighten all screws and cover the center cap.
NOTE
- Re-torque and check fasteners after 250 miles and frequently thereafter.
- Gross trailer weight (GTW):5000 lbs.; Tongue weight (TW):500 lbs. Never exceed the GTW and TW capacity recommended in the instruction manual when using.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>