HOOKE ROAD BXG.5201-S Tundra Rear Bumper Full Width Back Step Bumper with LED Lights Installation Guide
- June 1, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD BXG.5201-S Tundra Rear Bumper Full Width Back Step Bumper with
LED Lights
Tools required
- A. 18mm Wrench;
- B. 18mm Socket Wrench;
- C. 19mm Socket Wrench;
- D. 4mm Hex Socket Wrench
Installation time
- About 2 hours, 2-3 people may be needed. Installation time may differ according to your mechanical skill level.
- (PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION!)
- To view the electronic version (BXG.5201-S), please scan the QR code.
Installation instruction
Step 1
Remove the factory rear bumper, as the picture shows.
Step 2
Install this bumper into your vehicle with the bolts that we provide. The pictures are for reference only. The installation can be done without removing the light fixture as well.
Notes: Tighten those bolts after adjusting the height of the bumper.
Notes: Tighten those bolts after adjusting the front and back distance of
the bumper.
Step 3
The installation is complete. We hope you enjoy a wonderful off-road life with this quality product!
Attention
- The product parts in this instruction may differ slightly from the actual product contents but generally do not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of questions about your purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>