HD Ridez WB-DS258BD Black OE Style Nerf Bars Running Boards Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-DS258BD Black OE Style Nerf Bars Running Boards
PARTS LIST
PROCEDURE
REMOVE CONTENTS FROM THE BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
-
Start the installation under the driver’s side of the vehicle. Locate the front (3) factory studs along the inner side of the body panel, (Figure 1).
-
Select (1) Mounting Bracket. NOTE: All (6) Brackets are universal and will fit left or right side. Attach the Mounting Bracket to the (3) factory studs with (3) 8mm Flat Washers and (3) 8mm Nylon Lock Nuts, (Figure 2). Leave brackets loose at this time.
-
Repeat Steps 1 & 2 to install the Universal Brackets in the centre and rear mounting locations along the body panel, (Figures 3 & 4).
Driver/left Side Installation Pictured -
Carefully unwrap and select the Driver/left side Running Board. Use the illustration above to help determine the correct Running Board. NOTE: The front stepping pad on the Running board is closer to the end. Place the Running Board on top of the Brackets. IMPORTANT: Do not slide, (front to back), the Running Board on the Brackets or damage to the finish may result. Locate the channel opening at the bottom of the Running Board. Select (3) 6mm Double Bolt Plates, (Figure 5). Insert the Bolt Plates into the channel in the bottom of the Running Board closest to the Brackets, (Figure 6). Lift the Running Board and guide the studs through the Brackets.
-
Attach the Running Board to the Brackets with (6) 8mm Flat Washers and (6) 8mm Nylon Lock Nuts, (Figures 7 & 8).
-
Level and adjust the Running Board as necessary and fully tighten all hardware.
-
Repeat Steps 1-6 for Passenger/right side Running Board Installation.
-
Do periodic inspections of the installation to make sure that all hardware is secure and tight. To protect your investment, wax this product after installation.
-
Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used also to clean the Running Board.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>