HD Ridez WB-FD311BD Steel Construction Drop Down Style Running Boards Instruction Manual
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-FD311BD Steel Construction Drop Down Style Running Boards
Specifications
- Product: DS4 Running Boards 2021-24 Ford Bronco 4DR
- Part Number: WB-FD311BD
- Includes: Driver/Left and Passenger/Right DS4 Running Boards, Mounting Brackets, Bolts, Washers, and Nuts
Installation Steps
- Identify all the parts from the Parts List.
- Clean the Running Boards with mild soap before installation.
- Follow the specific mounting locations for each bracket as shown in the figures.
- Attach the Mounting Brackets using the provided hardware.
- Securely attach the Running Boards to the Mounting Brackets.
Mounting Instructions
Each Mounting Bracket should be attached to its designated location using the
specified hardware.
Cleaning and Maintenance
Avoid using abrasive polish or wax to prevent damage to the finish. Clean with
mild soap when needed.
INSTALLATION INSTRUCTIONS
DS4 RUNNING BOARDS
2021-24 FORD BRONCO 4DR
PART#WB-FD311BD
PARTS LIST
1 | Driver/Left DS4 Running Board | 1 | Passenger/Right Rear Mounting Bracket |
---|---|---|---|
1 | Passenger/Right DS4 Running Board | 24 | 10mm x 30mm Hex Bolts |
1 | Driver/Left Front Mounting Bracket | 12 | 10mm Lock Washers |
1 | Passenger/Right Front Mounting Bracket | 12 | 10mm x 27mm OD x 3mm Flat |
Washers
1| Driver/Left Center Mounting Bracket| 24| 10mm x 20mm OD x 2mm Flat Washers
1| Passenger/Right Center Mounting Bracket| 12| 10mm Nylon Lock Nuts
1| Driver/Left Rear Mounting Bracket| |
PROCEDURE
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
- Starting from underneath the Passenger/Right body panel, locate the front mounting location and the threaded holes in the body panel, (Figure 1). Remove the plastic plugs covering the holes.
- Select the Passenger/Right Front Mounting Bracket. Attach the Mounting Bracket to the front location with (2) 10mm Hex Bolts, (2) 10mm Lock Washers and (2) 10mm Flat Washers, (Figure 2). Do not tighten hardware.
- Repeat Steps 2 & 3 to attach Center Mounting Bracket and Rear Mounting Bracket to the center and rear locations, (Figures 3—6). Do not tighten hardware. NOTE: The Center and Rear Mounting Brackets are similar but are unique. The Center Mounting Brackets have a smooth back and the Rear Mounting Brackets will have a small hole in the back, (Figure 4).
- Select the Passenger/Right DS4 Running Board. Line up the mounting tabs on the Running Board to the rear faces of the Mounting Brackets. Attach the Running Board to the Mounting Brackets with (6) 10mm Hex Bolts, (12) 10mm x 20mm Flat Washers and (6) 10mm Nylon Lock Nuts, (Figure 7). Do not tighten hardware.
- Level and adjust the Running Board and tighten all hardware.
- Repeat Steps 1—6 to attach the Driver/Left DS4 Running Board.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used to clean the Running Boards.
Passenger/Right side Installation Pictured
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>