bluebuilt BBBB22 Adjustable Universal Projector Mount User Guide

bluebuilt BBBB22 Adjustable Universal Projector Mount User Guide

Materials

1. Clamps,

2. ceiling plate,

3. cover,

4. bar,

5. screws and plugs,

6. bolts without washers,

7. bolts with raised washers,

8. bolts with flat washers,

9. intermediate piece.
   
   Tools

10. Drill,

11. drill bit,

12. pencil,

13. Allen key (included),

14. screwdriver
    

INSTALLATION

1. MARK OFF THE DRILL HOLES
   Mark the drill holes using the ceiling plate 2 . So you’re sure you’re drilling in the right places
   

2. MOUNT THE CEILING PLATE
   Drill holes up to 5 centimetres deep and screw the ceiling plate 2 with the long screws and plugs 5 .
   

3. MOUNT THE COVER AND BAR
   Place the cover 3 on the ceiling plate 2 and attach the bar to the suspended ceiling plate 2 . You do this with the bolts 6 and the Allen key 13 . Please note: on the photo the ceiling plate does not hang, but for you it does. Also check that the nuts are present in the white plate of the ceiling plate. If not, you will find them loose in the box
   

4. SCREW THE CLAMPS IN PLACE
   Tighten the clamps 1 almost completely with the screwdriver. To do this, use the bolts with raised washers 7 . Take the intermediate piece 9 to check that the screw holes are properly positioned. If this is the case, tighten the clamps to the projector.
   

5. TIGHTEN THE INTERMEDIATE PIECE
   Use the Allen key 13 and screws with flat  washers 8 to attach the intermediatepiece 9 to the clamps 1 . Note that the screw hole at the top of the intermediate piece points straight forwards.
   

6. HANG UP THE PROJECTOR
   Attach the projector to the hanging bar 4 and tighten the last bolts 6 with the Allen key 13 .
   

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>