HD Ridez WB-FN175SMD Wheel to Wheel Drop Down Style Running Boards Side Step Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
Installation Guide
WB-FN175SMD Wheel to Wheel Drop Down Style Running Boards Side Step
INSTALLATION INSTRUCTIONS
NBI WHEEL TO WHEEL RUNNING BOARDS 2015-24 FORD F150 SUPER CREW CAB 5.SFT
BED/2022-2024 F150 LIGHTNING
PART# WB-FNI75SMD
NB1 WHEEL TO WHEEL RUNNING BOARDS 2015-24 FORD F150 SUPER CREW CAB 5.5FT
BED/2022-2024 F150 LIGHTNING
PARTS LIST:
| 1 | Driver/Left Running Board | 24 | 10mm x 27mm x 3mm Washers |
|---|---|---|---|
| 1 | Passenger/Right Running Board | 12 | 10mm Nylon Lock Nuts |
| 6 | Mounting Brackets | 18 | 8mm x 24mm x 2mm Washers |
| 18 | 8mm Plastic Retainers | 18 | 8mm Nylon Lock Nuts |
| 12 | 10mm x 35mm Hex Bolts |
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
-
Start the installation under the driver/left side of the vehicle. Locate the front factory running board mounting location along the inner side of the body, (Figure 1).
-
Slide (1) Plastic Washer over each of the (3) factory mounting studs in the body panel, (Figures 2 & 3).
IMPORTANT: The Plastic Washers are designed to prevent corrosion between the aluminum body panel and the steel mounting brackets. Do not install the Brackets without the Plastic Washers. -
Select (1) Mounting Bracket. NOTE: All (6) Brackets are universal and will fit left or right side. Attach the Mounting Bracket to the (3) factory studs with (3) 8mm Flat Washers and (3) 8mm Nylon Lock Nuts, (Figures 4 & 5). Do not tighten hardware.
-
Repeat Steps 1—3 to attach (2) Mounting Brackets to the center and rear locations.
-
Carefully unwrap the Driver/Left Running Board. With assistance, line up the Running Board with the back of the Brackets. Attach the tabs on the Running Board to the rear facing side of the Brackets with (6) 10mm x 35mm Hex Bolts, (12) 10mm Fiat Washers and (6) 10mm Nylon Lock Nuts, (Figure 6). Do not tighten hardware.
-
Level and adjust the Running Board as necessary and fully tighten all hardware.
-
Repeat Steps 1—6 for the passenger/right side Running Board installation.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used also to clean the Running Board.
NB1 WHEEL TO WHEEL RUNNING BOARDS
2015-24 FORD F150 SUPER CREW CAB 5.5FT BED/2022-2024 F150 LIGHTNING
Driver/Left Side Installation Pictured
6/27/22(EL)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>