HOOKE ROAD BXG.8260 Guardian Rear Bumper With LED Lights Installation Guide
- June 1, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD BXG.8260 Guardian Rear Bumper With LED Lights
Contents
Tools required
- Drive Socket Ratchet Wrench
- 19mm Shallow Socket
- 19mm Wrench
Installation time
About 1 hour, 1-2 people may be needed. Installation time may differ according to your mechanical skill level. (PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION!) To view the electronic version (BXG.8260), please scan the QR code.
Installation instruction
Step 1
Remove the factory vehicle’s rear bumper. Due to space constraints, I
recommend that you search for relevant videos online to find the car
dismantling steps. You can easily find them for detailed guidance. in
preparation for the installation of our product.
Step 2
First, insert the mounting bracket into the bumper, distinguishing between the
passenger side and the driver’s side. The figure below illustrates the
installation on the passenger side. Use M12*30 bolts and nuts during
installation, but do not tighten the screws.
Step 3
After installing the mounting bracket, lift the bumper and align it with the
body mounting holes. Then, screw in the M12*35 bolts and nuts. However, you
may need to adjust the body gap, and once it’s adjusted properly, tighten all
the screws.
Step 4
The installation is complete. We hope you enjoy a wonderful off-road life with this quality Hooke Road product!
Attention
- The product parts in this instruction may differ slightly from the actual product contents but generally do not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of questions about your purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>