SLV 1007668 Wall LED Light Installation Guide
- June 1, 2024
- SLV
Table of Contents
1007668 Wall LED Light
INSTRUCTION MANUAL PART A Wall Light
The installation requires expert knowledge and may be carried out only by an
approved electrician under consideration of local and national regulations!
Technical Details are subject to change.
****SLV UK
Unit E Chiltern Park
Boscombe Read, Bedfordshire
LUS 4LT
Operating Manual PART B
Wall Light
1007668
Read manual carefully and keep for further use!
Safety advices for installation and operation.
Disregard may lead to danger of life, burning or fire!
Any works on the electrical connection only by electrician.
Do not alter or modify the product.
Do not fasten anything on the product.
Do not cover the product.
Operate only with intact protection glass.
Take out of service when suspecting a defect or malfunction and contactyour
dealer or a qualified electrician.
Take measures that children get not harmed by the product.
Do not stare into the active light source.
Additional safety advices =
Use as directed
Safety class I (1) – Connection with protective conductor.
Operate only firmly fixed on an even surface.
Operate only on normal or not inflammable surfaces.
Do not strain mechanically or expose to strong dirt contamination.
IP65: Protection against dust (dust-tight) – Protection against jetted water
from all directions.
Admissible ambient temperature(ta): -20°C …+40°C.
Light Source
The light source of this luminaire may only be replaced by the manufacturer,
an authorized service technician or a comparable qualified person.
This product contains a light source of the energy efficiency class E.
Reference control setting: 3000K
Care/Storage
Disconnect product from mains and let it cool down.
Clean external surfaces regularly with a slightly moistened (water) cloth.
Do not clean with pressure washer.
Openings providing aeration or drainage must be kept free.
The following influences may have unwanted effects on the product: acidic
surrounding, high salt content in the air, cleaning agents, fertilizer,
thawing salt, chemicals.
Store dry and clean.
Installation
Switch off mains/fixed connection cable!
Use only described accessories.
Use only suitable fastening materials.
Only suited for wall surface mounting.
Follow local regulations for outdoor installations.
Do not seal the product yourself (e.g. with silicone).
Install according to declared IP type.
Install as shown in the figure.
Suitable Dimmer: Trailing-edge phase dimmer (Code C). Note manufacturers
instructions.
Electrical connection
Direct the fixed wiring with its complete insulation at least 15 mm into the
housing.
Equip flexible wire ends with suitable wire ferrules!
Live conductor → Terminal L
Neutral conductor → Terminal N
Protective conductor → Earth terminal
Up to 30 luminaires may be connected in one row.
Check secure fixation and proper function!
© 16.06.2023 SLV GmbH, Daimlerstr. 21-23, 52531 Übach-Palenberg, Germany, Tel.
+49 (0)2451 4833-0.
Made in China.