SLV OVLISK Wall Light with Motion Sensor Instruction Manual
- June 4, 2024
- SLV
Table of Contents
SLV OVLISK Wall Light with Motion Sensor
SPECIFICATION
TOOLS
INSTALLATION
WARNING: The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!
The light source is only exchangeable by a professional. The separate control unit is only exchangeable by a professional.
Disposal (European Union)
Do not dispose the product with the regular household waste! Products marked with this sign must be disposed according to the directive (WEEE) on electrical and electronic devices at local collection points for such devices!
OPERATION
Read the manual carefully and keep for further use!
- Safety advice for installation and operation.
- Disregarding may lead to the danger of life, burning or fire!
- Any works on the electrical connection only by the electrician.
- Do not alter or modify the product.
- Do not fasten anything on the product.
- Do not cover the product.
- Operate only with intact protection glass.
- Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician.
- Take measures that children get not harmed by the product.
- Do not stare into the active light source.
Additional safety advice =
Use as directed
- Safety class I (1) Connection with protective conductor.
- Do not operate indoors.
- Operate only firmly fixed on an even surface.
- Operate only on normal or not inflammable surfaces.
- Do not strain mechanically or expose to strong dirt contamination.
- IP65: Protection against dust (dust-tight) – Protection against jetted water from all directions.
- Admissible ambient temperature(ta): -20°C …+45°C.
Light Source
The light source of this luminaire may only be replaced by the manufacturer, an authorized service technician or a comparable qualified person. This product contains a light source of the energy efficiency class D. Reference control setting: 4000K
Care / Storage
Disconnect the product from the mains and let it cool down. Clean external surfaces regularly with a slightly moistened (water) cloth. Do not clean with a pressure washer. Openings providing aeration or drainage must be kept free. The following influences may have unwanted effects on the product: acidic surroundings, high salt content in the air, cleaning agents, fertilizer, thawing salt, and chemicals. Store dry and clean.
Installation
- Switch off mains / fixed connection cable!
- Use only described accessories.
- Use only suitable fastening materials.
- Only suited for wall surface mounting.
- Follow local regulations for outdoor installations.
- Do not seal the product yourself (e.g. with silicone).
- Install according to the declared IP type.
- Install as shown in the figure.
Electrical connection
Direct the fixed wiring with its complete insulation at least 15 mm into the housing. Equip flexible wire ends with suitable wire ferrules!
- Live conductor Terminal L
- Neutral conductor Terminal N
- Protective conductor Earth terminal
Check secure fixation and proper function!
Detection Adjustment
The sensor is active until the surrounding light reaches the adjusted lux value.
© 01.05.2021 SLV GmbH,
- ADDRESS: Daimlerstr. 21-23, 52531 Übach-Palenberg, Germany,
- Tel: +49 (0)2451 4833-0.
Made in China.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>