SLV 1007581 Wall Light Instruction Manual

SLV 1007581 Wall Light

Product Information

• Specifications:
  • IP Rating: IP55
  • Model Numbers: 1007581, 1007585
  • Dimensions:
  • Maximum Height: 11.6 cm
  • Maximum Width: 6.0 cm

Product Usage Instructions

• Installation:
  • The installation of this product requires expert knowledge and should only be carried out by an approved electrician in compliance with local and national regulations.
• Safety Guidelines:
  • Read the manual carefully for installation and operation.
  • Do not alter or modify the product.
  • Operate only with intact protection glass.
  • Take out of service if there is a defect or malfunction and contact a qualified electrician.
  • Ensure children are not harmed by the product.
• Lamp Replacement:
  • Disconnect the luminaire from the mains and allow it to cool down before replacing the lamp. Use suitable light sources such as E27, 13W max. Clean gasket when dirty.
• Care and Storage:
  • Disconnect the product from the mains and let it cool down before cleaning.
  • Clean external surfaces regularly with a slightly moistened cloth.
  • Do not use a pressure washer for cleaning.
  • Ensure openings for aeration or drainage are clear.
  • Avoid exposure to acidic surroundings, high salt content, or chemicals. Store the product in a dry and clean place.
• Electrical Connection:
  • Switch off the mains before connecting.
  • Direct the fixed wiring at least 15 mm into the housing.
  • Equip flexible wire ends with suitable wire ferrules. Check for secure fixation and proper function.
• Additional Notes:
  • Operate only on normal or non-inflammable surfaces.
  • Avoid mechanical strain and strong dirt contamination.
  • Follow local regulations for outdoor installations.
  • Do not seal the product yourself.
• FAQ:
  • Q: Can I install this product myself?
  • A: The installation should be carried out by an approved electrician due to the expert knowledge required and compliance with regulations.
  • Q: What type of light sources can be used for replacement?
  • A: Suitable light sources include E27 bulbs with a maximum power of 13W.

DIMENSION

HARDWARE

INSTRUCTION MANUAL PART A Wall Light

The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!

Operating Manual PART B Wall Light

Operating Manual PART B Wall Light 1007581 …85

• Read the manual carefully and keep it for further use!
  • Safety advice for installation and operation.
  • Disregarding may lead to danger of life, burning or fire!
  • Any work on the electrical connection only by the electrician.
  • Do not alter or modify the product.
  • Do not fasten anything on the product.
  • Do not cover the product.
  • Operate only with intact protection glass.
  • Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician.
  • Take measures that children are not harmed by the product.
  • Additional safety advice =

Use as directed

• Safety class I (1) – Connection with protective conductor.
• Operate only firmly fixed on an even surface.
• Operate only on normal or not inflammable surfaces.
• Do not strain mechanically or expose to strong dirt contamination.
• IP55: Protection against disturbing dust deposition – Protection against jetted water from all directions.

Lamp replacement

• Disconnect the luminaire from the mains and let it cool down.
• Suitable light sources: E27, 13W max.
• Clean gasket when dirty.

Care Storage

• Disconnect the product from the mains and let it cool down.
• Clean external surfaces regularly with a slightly moistened (water) cloth.
• Do not clean with a pressure washer.
• Openings providing aeration or drainage must be kept free.
• The following influences may have unwanted effects on the product: acidic surroundings, high salt content in the air, cleaning agents, fertilizer, thawing salt, and chemicals.
• Store dry and clean.

Installation

• Switch off mains / fixed connection cable!
  • Use only described accessories.
  • Use only suitable fastening materials.
  • Only suited for wall surface mounting.
  • Follow local regulations for outdoor installations.
  • Do not seal the product yourself (e.g. with silicone).
  • Install according to the declared IP type.
  • Install as shown in the figure.

Electrical connection

Direct the fixed wiring with its complete insulation at least 15 mm into the housing.
Equip flexible wire ends with suitable wire ferrules!

• Live conductor Terminal L
• Neutral conductor Terminal N
• Protective conductor Earth terminal

Check secure fixation and proper function!

• © 0001 12.07.2023 SLV GmbH,
• Daimler. 21-23, 52531 Übach-Palenberg, Germany,
• Tel. +49 (0)2451 4833-0. Made in China.
• 1007581
• 1007585

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>