Soundskins Classic Bulk Kit Installation Guide

June 17, 2024
soundskins

Soundskins Classic Bulk Kit

Specifications

  • Brand: SoundSkins
  • Model: InsulationPro
  • Material: Adhesive Insulation
  • Size: Various sizes available
  • Color: Black

Product Usage Instructions

  1. Inspect the installation area for any trapped air bubbles.
  2. If air bubbles are present, use a razor blade or sewing needle to gently poke a hole and press down on the material to release the air.
  3. Ensure that the adhesive side of the insulation has proper contact with the metal surface for effective adhesion.
  4. Check that any holes required for fastening hardware are clear and unobstructed.
  5. Repeat the above steps for the entire installation process to guarantee lasting adhesion and maximum insulation efficiency.

Contact Information

If you have any questions or need further assistance, please feel free to contact us: Soundskins USA 13452 Alondra Blvd, Cerritos, CA 90703

FAQ

Q: Can I reuse the insulation material after removal?
A: The adhesive insulation material is designed for one-time use only and may not be as effective if reused.

Q: Can the insulation be painted over?
A: It is not recommended to paint over the insulation material as it may affect its performance.

Q: Is the insulation material waterproof?
A: While the material provides some water resistance, it is not completely waterproof and should not be submerged in water.

Recommended Installation Instructions

Prepping the Surface
Start by getting all metal surfaces clean of dust, debris, oil, wax, and moisture. For this, we recommend a microfiber cloth, a breathing mask, and a quick-drying solvent such as Acetone. If you have some rust, it may require a bit more attention and detail to ensure the material will stick well. Once all the surfaces have been prepped and properly air dried, we can start applying material. Our material is unique, so a household pair of scissors, exacto knife, or razor blade can be used to cut whatever shapes you need.

Installation

Place the material on a flat surface and you can measure the size you will need (paper or cardboard can be used to cut templates). After you have made your cut, peel off the white paper on the back covering the adhesive. When you’re ready to apply, pick a place to start (it is best to start from the top down) so you can work the material all one direction and minimize any trapped air pockets. You can push the material with your hand with medium pressure outwards until the material has complete contact. If you see any possible trapped air, you can use the point of a razor blade or a sewing needle to poke a hole and push down the material. The main focus is to ensure the adhesive has proper contact with the metal surface. Check that any holes that require fastening hardware are not blocked. Repeat this step for the remainder of the installation and ensure lasting adhesion with the maximum insulation. If you have questions, don’t hesitate to contact us using the information provided below.

Soundskins USA 13452 Alondra BIvd, Cerritos, Ca 90703

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals