soundskins Sedan Door Kit Instructions
- June 3, 2024
- soundskins
Table of Contents
soundskins Sedan Door Kit Instructions
Tools needed for installation:
- Panel/trim tool
- Roller
- Screw driver
- Microfiber cloth
- Acetone or cleaning solution
- Razor blade
Installation Instruction
-
Start by locating the fastening hardware on the door panel. Take the appropriate screw driver and remove.
Once all the screws are removed you can take off the door panel gently using a panel tool, watching that you don’t break any of the clips or mounting hardware. -
Pull the panel away slowly and unplug any electrical connections.
-
Now you are ready to prep the metal surface using a microfiber cloth and Acetone (or other cleaning solution).
Wipe away any moisture, oil, debris, etc. Then, let it air dry for an appropriate time. The point is to get the surface clean to ensure material glue contact. -
Locate the piece of the kit with the label on the back that coincides with the door you’re working on. Make sure it lines up and is correct before you pull the white cover paper off. After you confirm the right piece, pull off the white paper and use a roller to apply the material at the top and work your way down. Use a razor blade or household needle to release air. Repeat for all door panels.
-
Now you are ready to place the door panel back on your door. All necessary openings will be available after you have applied the Sound Skins material. Secure your door panels with all screws and enjoy your quiet new ride!
Recommended Installation Instructions
-
A. Prepping the Surface
After removing interior door panels you are ready to clean the metal areas that will be insulated. If the metal has “new” look without imperfections then take a microfiber cloth and wipe away any dust and debris. If the metal is showing signs of age like rust then we recommend using Acetone with a breathing mask to wipe off debris and loose particles. A shop vacuum might be needed to remove loose debris on the floorboard. -
B. Installing Panels
Now that you have a clean surface you are ready to start applying the sheets. We recommend a roller to release air pockets that might be lingering from trapped air. You want to make sure that you have rolled those out to the edge and all the material has a good seal to the metal surface. Make sure all pieces are installed and inspected before reinstalling the interior.
- Driver Front Door Panel
- Driver Rear Door Panel
- Passenger Front Door Panel
- Passenger Rear Door Panel
Customer Support
YOU’RE NOW READY TO HIT THE ROAD!
SoundSkins USA
13452 Alondra Blvd, Cerritos, Ca 90703
Phone: 877.211.5597
Email: team@soundskinsglobal.com
www.SoundSkinsGlobal.com
