soundskins SSK-GLDTR4DR 4 Door Sound Deadening Pack Instructions
- June 4, 2024
- soundskins
Table of Contents
Jeep Door Kit Instructions
Tools needed for installation:
• Panel/trim tool| • Microfiber cloth
• Roller| • Acetone or cleaning solution
• Screwdriver| • Razor blade
• Rubber wedge|
SSK-GLDTR4DR 4 Door Sound Deadening Pack
-
Start by locating the fastening hardware on the door panel, take the appropriate screwdriver and remove it.
-
Once all the screws are removed you can take off the door panel gently watching that you don’t break any of the clips or mounting hardware. Pull the panel away slowly and
unplug any electrical connections. -
You will find an insert that needs to be removed, with mounting screws and cables that control the door handle and locking mechanism. Slowly pull the insert away and pull
through the cables to give yourself some slack. -
Next you need to prop the window up by either a rubber wedge or simply put a screwdriver through the bottom hole as illustrated.
-
Now you are ready to prep the metal surface using a microfiber cloth, Acetone (use a breathing mask), and wipe away any moisture, oil, debris or etc. Then let air dry for an
appropriate time. The point is to get the surface clean to ensure material glue contact. -
When the surface is dry and clean, locate the piece of the kit with the label on the back that coincides with the door you are working on. Make sure it lines up correctly before pulling the white cover paper off. After you confirm the right piece, pull off the backing paper and start placing the material at the top, working your way down with a roller. Make sure that the material is rolled down completely and no air is trapped. Use a razor blade point or household needle to release any air. Repeat these steps for all door panels.
SKU: SSK-GLDTR4DR
INSTALLATION VIDEO
https://www.youtube.com/watch?v=Z326yupHddQ&t=5s
Scan code for the “how to” video!
**Recommended Installation Instructions
**
A. Prepping the Surface
After removing interior door panels you are ready to clean the metal areas
that will be insulated. If the metal has a “new” look without imperfections
then take a microfiber cloth and wipe away any dust and debris. If the metal
is showing signs of age like rust then we recommend using Acetone with a
breathing mask to wipe off debris and loose particles. A shop vacuum might be
needed to remove loose debris on the floorboard.
B. Installing Panels
Now that you have a clean surface you are ready to start applying the sheets.
We recommend a roller to release air pockets that might be lingering from
trapped air. You want to make sure that you have rolled those out to the edge
and all the material has a good seal to the metal surface. Make sure all
pieces are installed and inspected before reinstalling the interior.]
1) Driver Front Door Panel 2,3,4) Driver
Rear Door Panel
5) Passenger Front Door Panel 6,7,8) Passenger Rear Door Panel
YOU’RE NOW READY TO HIT THE ROAD!
Sounds kind USA
13452 Alondra Blvd, Cerritos, Ca 90703
Phone: 877.211.5597
Email: team@soundskinsglobal.com
www.SoundSkinsGlobal.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>