soundskins F-150 4-Door Template Kit Instruction Manual
- June 4, 2024
- soundskins
Table of Contents
F-150 4-Door Template Kit
Instruction
Manualhttps://www.youtube.com/watch?v=IhdQsqyIoXQ&t=3s
Recommended Installation Instructions
A. Prepping the Surface
After removing the interior door panels, you are ready to clean the metal
areas that will be insulated. If the metal has a “new” look without
imperfections, then take a microfiber cloth and wipe away any dust and debris.
If the metal is showing signs of age like rust, we recommend using Acetone
with a breathing mask to wipe off debris and loose particles. A shop vacuum
might be needed to remove loose debris on the floorboard.
B. Installing Panels
Now that you have a clean surface, you are ready to start applying the sheets.
We recommend using a roller to release air pockets that might be lingering
from trapped air. You want to make sure that you have rolled those out to the
edge and that all the material has a good seal to the metal surface. Make sure
all pieces are installed and inspected before reinstalling the interior.
- Driver Front Door Panel
- Driver Rear Door Panel
- Passenger Front Door Panel
- Passenger Rear Door Panel
Truck Door Kit Instructions
-
Start by locating the fastening hardware on the door panel, take the appropriate screwdriver and remove it.
-
Once all the screws are removed you can take off the door panel gently watch! making that you don’t break any of the clips or mounting hardware.
-
Pull the panel away slowly and unplug any electrical connections.
-
Now you are ready to prep the metal surface using a microfiber cloth, Acetone (use a breathing mask), and wipe away any moisture, oil, debris or etc. Then let air dry for an appropriate time. The point is to get the surface clean to ensure material glue contact.
-
When the surface is dry and clean, locate the piece of the kit with the label on the back that coincides with the door you’re working on. Make sure it lines up and is correct before you pull the white cover paper off. After you confirm the right piece, pull off the white paper and start placing the material at the top and work your way down. Most important is that the material is pushed down completely and that no air is trapped. Use a razor blade point or household needle to release air. Repeat these steps for all door panels.
-
Now you are ready to place the door panel back on your door. All necessary openings will be available after you have applied the Soundskins material. Secure the door panel with all screws and you are now ready to hit the road.
ENJOY!
Sounds like the kind USA
13452 Alondra Blvd, Cerritos, Ca 90703
Phone.: 562.689.5151
Email: info@soundskinsglobal.com
www.SoundSkinsGlobal.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>