soundskins 239BRON4DR Bronco Kit Door Instruction Manual
- June 4, 2024
- soundskins
Table of Contents
soundskins 239BRON4DR Bronco Kit Door
Installation Instructions
Tools needed for installation:
- 7mm socket
- Socket extension
- Panel /trim tool
- Roller
- Microfiber cloth
- Acetone or cleaning solution
Scan this code to watch the full instructional video!
- Start by locating the fastening hardware on the door panels. There will be one behind the door handle under a plastic cover, one behind the door grab handle that you will have to pop out to reveal, and 2 at the bottom right corner of the door panels. Take a 7 mm socket and remove. Then, use a panel tool to pry the panel off the door, start from the bottom right corner. Be sure not to break any clips or mounting hardware.
- Pull the door panel away slowly. There will be 2 plug clips that will need to be released as well as a wire plug to disconnect. Set the door panel aside and unhook all plugs, remove the vapor barrier, and clean the car metal surface using a microfiber cloth and Acetone or other cleaning solution. The point is to get the surface clean to ensure material glue contact.
- Now, apply the door pieces. Peel off the backing paper starting at the top, tack the piece onto the door and work your way down, pressing down the material and pulling down the backing paper more as you go along. Feed the harnesses through the proper holes and ensure everything is aligned before pressing the entire piece down. Repeat steps 1-3 for all doors. Then replace your door panels and reconnect the wires and enjoy your quiet new ride!
Recommended Installation Instructions
-
A. Prepping the Surface
After removing interior door panels, you are ready to clean the metal areas that will be insulated. If the metal has a “new” look without imperfections, then take a microfiber cloth and wipe away any dust and debris. If the metal is showing signs of age like rust, we recommend using Acetone with a breathing mask to wipe off debris and loose particles. A shop vacuum might be needed to remove loose debris on the floorboard. -
B. Installing Panels
Now that you have a clean surface, you are ready to start applying the sheets. We recommend using a roller to release air pockets that might be lingering from trapped air. You want to make sure that you have rolled those out to the edge and all the material has a good seal to the metal surface. Make sure all pieces are installed and inspected before reinstalling the interior.
- Driver Front Door Panel
- Driver Rear Door Panel
- Passenger Front Door Panel
- Passenger Rear Door Panel
Soundskins USA
13452 Alondra Blvd, Cerritos, CA 90703 Phone: 877.211.5597
Email: team@soundskinsglobal.com
www.SoundSkinsGlobal.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>