soundskins 239SSPROSK 4-Piece Speaker Kit Instruction Manual
- June 5, 2024
- soundskins
Table of Contents
Recommended Installation Instructions
Prepping the Surface
Start by getting all metal surfaces clean from dust, debris, oil, wax and
moisture. For this we recommend a microfiber cloth, a breathing mask, and a
quick drying solvent such as Acetone. If you have some rust, it is possible it
requires a bit more attention and detail to ensure the material will stick
well. Once all the surfaces have been prepped and properly air dried, we can
start applying material. Our material is unique, so a household pair of
scissors, exacto knife, or razor blade can be used to cut whatever shapes you
need.
Installation
Roll the material out on a flat surface and you can measure the size you will
need (paper or cardboard can be used to cut templates). After you have made
your cut, peel off the white paper on the back covering the adhesive. When
you’re ready to apply, pick a place to start (it is best to start from the top
down) so you can work the material all one direction and minimize any trapped
air pockets. You can push the material with your hand a with medium pressure
outwards until the material has complete contact.
If you see any possible trapped air, you can use the point of a razor blade or a sewing needle to poke a hole and push down on the material. The main focus is to ensure the adhesive has proper contact to the metal surface. Check that any holes that require fastening hardware are not blocked. Repeat this step for the remainder of the installation and ensure lasting adhesion with the maximum insulation. If you have questions, don’t hesitate to contact us using the information provided below.
Soundskins USA
13452 Alondra Blvd, Cerritos, Ca 90703
Phone: 562.689.5151
Email:info@soundskinsglobal.com
www.SoundSkinsGlobal.com
Documents / Resources
|
soundskins 239SSPROSK 4-Piece Speaker
Kit
[pdf] Instruction Manual
239SSPROSK 4-Piece Speaker Kit, 239SSPROSK, 4-Piece Speaker Kit
---|---