soundskins 1703121319 4 Piece Speaker Kit Instructions
- June 17, 2024
- soundskins
Table of Contents
Sound skins 1703121319 4 Piece Speaker Kit
Specifications
- Product: Speaker Kit
- Manufacturer: SoundSkins Global
- Contact: USA (877)211-5597 / usa@SoundSkinsGlobal.com
- Website: www.SoundSkinsGlobal.com
Prepping the Surface
- Remove the door panel, speaker, and vapour barrier near the speaker hole.
- Clean all metal surfaces from dust, oil, wax, and moisture using a microfiber cloth and Acetone solvent.
- If there is rust, ensure proper cleaning to allow the material to adhere well.
- Let the surfaces air dry before proceeding with installation.
First, remove your door panel, speaker, and vapour barrier if it is near the speaker hole. Get all metal surfaces clean from dust, oil, wax and moisture. We recommend using a microfiber cloth and a quick-drying solvent such as Acetone. If you have rust, it may require more attention to ensure the material will stick well. Let the surface air dry, then it is ready for installation.
Installation Steps
- Repeat the surface preparation steps for all speaker holes.
- Ensure the surfaces are clean and dry before moving forward.
- Proceed with installing the Speaker Kit following the provided installation instructions.
Finalizing Installation
- After completing the installation, your setup should resemble the provided image.
- Reinstall the speaker and door panel to experience a quieter ride and improved audio quality.
All required tools
Installation
Centre the material over the speaker hole. This is where each piece should be installed. When you are ready to apply the material, remove the backing paper and start from the top down using a roller to minimize any trapped air pockets. If you see any trapped air, you can use the point of a razor blade or a sewing needle to poke a hole and push down the material. Press down tautly on the material around the speaker hole. Use a blade to cut the material along the edge of the speaker hole of the speaker making sure not to cut any wires. Place this cutout piece directly behind the speaker (inside the speaker hole), to act as a back wave to improve bass response.
Repeat this step for all speaker holes, then your installation is complete. It should look like the image on the left. Last, replace the speaker and the door panel to enjoy a quieter ride and an improved audio system. If you have any questions, don’t hesitate to reach out with the information provided below.
SoundSkins Global USA
usa@SoundSkinsGlobal.com
www.SoundSkinsGlobal.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>