Z-Lite 560S-DBZ-LED Luminata 5 1 Light LED Deep Bronze Outdoor Wall Sconce Instruction Manual
- June 17, 2024
- Z-Lite
Table of Contents
560S-DBZ-LED Luminate 5 1 Light LED
Deep Bronze Outdoor Wall Sconce
Instruction Manual
560S-DBZ-LED Luminate 5 1 Light LED Deep Bronze Outdoor Wall Sconce
ASSEMBLY
INSTRUCTIONS
553S-LED & 553M-LED & 553B-LED
560S & 560M & 560B
READ & SAVE
INSTALLATION & OPERATION INSTRUCTIONS TOOLS & MATERIALS REQUIRED
Screwdriver Wire Cutters
Adjustable Wrench Wiring Supplies
CAUTION
Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not have
electrical wiring experience, refer to a do-it-yourself wiring handbook or
have your fixture installed by a qualified licensed electrician.
GENERAL
- Be sure to read these instructions and review the diagrams thoroughly before beginning.
- Electrical connections must be in accordance with local codes, ordinances, or the National Electric Code. If you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified licensed electrician.
- Before starting the installation, disconnect the power by turning off the circuit breaker or by removing appropriate fuse at fuse box. Turning the power off at the light switch is not sufficient to prevent electrical shock.
PREPARE THE FIXTURE
NOTE: First turn off electricity
Detach the circular strap from the backplate and mount the circular strap to
the outlet box in your wall using the two screws provided.
ELECTRICAL CONNECTIONS 120V~, 60Hz
Connect white wire(s) from fixture to white neutral wire from supply circuit.
Connect black wire(s) to black hot wire from supply circuit. Connect green
wire to green or bare wire or grounding screw on mounting bracket. In all
cases grounding conductor to earth must be used. Use UL/CSA Listed wire
connects suitable for the size, type, and number of conductors. No loose
strands or loose wires should be present. Secure wire connectors with UL/CSA
Listed electrical tape.
- Spread electrical splices so black wires are on one side of outlet box and white wires on the other.
- Mount the body of the fixture on the screws protruding from circular strap mounted on outlet box. The screw will protrude through holes of the back plate of fixture and be fastened with the decorative knobs. Be careful not to pinch any of the wires between the fixture and the outlet box.
- Once the fixture is mounted on the wall, caulk the space between the wall and the upper area of the back plate to prevent water seeping into the outlet box. Leave the bottom area un-caulked for drainage of any water which might leak into the enclosure.
- Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light switch on to activate the fixture.
- LED replacement, take down the glass with metal parts, unscrew the screws on LED and pull out LED module, replace LED module by quick connector. Then feed the new LED module back and secure with screws.
CAUTION: LED fixtures can operate at high temperatures please use caution when touching during operation or after operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>