VIDEX VL-BNW-T8122G LED Linear Lamp Light Instruction Manual

June 16, 2024

VIDEX VL-BNW-T8122G LED Linear Lamp Light



  1. Rated input voltage (V) and frequency (Hz);

  2. Maximum power of the light source (W);

  3. Type of compatible light source;

  4. Type of base/holder;

  5. Class of protection against dust and moisture. The product is protected from dust and water jets;

  6. The design of the product provides for replacement of the light source by the end user:

  7. Class of protection against mechanical influences;

  8. The product can be installed on the ceiling:

  9. The product can be installed on the wall;

  10. Operating temperature range (°C);

  11. Class of protection against electric shock I. A product in which the means of protection against electric shock, in addition to the main insulation, is an additional protective circuit connected to the grounding of the power supply network;

  12. The product can be used either indoors or outdoors:

  13. A damaged light diffuser/screen must be replaced;

  14. The product complies with the technical regulations of Ukraine;

  15. The product meets the requirements of EU directives;


  1. Pursuant to the provisions of the WEEE Act, it is forbidden to put waste equipment marked with the symbol of a crossed bin together with other waste. The user, wishing to get rid of electronic and electrical equipment, is obliged to return it to a waste equipment collection point. There are no hazardous components in the equipment that have a particularly negative impact on the environment and human health.
  • Product dimensions in (mm), weight (g/kg), production date and batch number are indicated on individual packaging;
  • Product materials: polycarbonate, iron, stainless steel;
  • The shelf life before the start of use is unlimited;


Intended for use in difficult conditions, such as a high level of pollution, moisture or where there is a risk of mechanical influences on the product.


  • The Fixture;
  • A set of fastening elements;
  • User manual;
  • Individual packaging.


Before installation, it is necessary to read the instructions. Installation must be performed by a specialist with appropriate qualifications. Installation and connection can only be carried out when the power supply is switched off. Two methods of installation are provided for this product: overhead onto flat surfaces; suspended (using separate elements that are not included in the set). Please install and connect according to the diagram below. The product has a ground wire. Failure to connect the ground wire may result in possible electric shock. Before the first use, it is necessary to check the correctness of the mechanical fastening and connection. The product can only be used in a network that meets the energy requirements and quality standards stipulated by law.


The product can be used either indoors or outdoors.


Any maintenance works should be carried out with the electricity switched off and the product should be cooled down and dry. Do not cover the fixture with heat-insulating materials, ensure free access of air. Clean only with soft and dry cloths. Do not use chemical detergents. The product may only be supplied with rated voltage or voltage within the given range. It is forbidden to use the product with a damaged light diffuser, damaged wiring or connection points. The product cannot be used in adverse conditions, e.g. vibration, explosive atmosphere, fumes or chemical fumes, etc. Only light sources listed in this manual may be used in the product. A used or damaged product should be disposed of in accordance with current regulations.


Before delivery to the direct point of sale, the product must be stored in the manufacturer’s packaging at a temperature from -20°C to +40°C, in a dry room and without exposure to direct sunlight. Transportation can be carried out by land, sea, air transport in the manufacturer’s transport packaging.


The warranty period for the product is indicated on the individual packaging and begins from the date of sale. During the warranty period, a faulty product can be exchanged or returned with prove of purchase and all components and accessories preserved. The following does not apply with the scope of limited warranty:

  •  Misuse the product and cause the products components damage;
  • Unauthorized disassemble or the presence of deep mechanical damage to the product;
  • Damage due to force majeure.

The manufacturer reserves the right to make changes to these user manual or technical changes to the product without prior notice.
Importer: Allegro Opt Sp. z o.o., Handlowa 23, 05-120 Legionowo, Polska. Made in China/Wyprodukowano w Chinach.

Read User Manual Online (PDF format)


Download This Manual (PDF format)

Download this manual  >>

VIDEX User Manuals

Related Manuals