VIDEX VLF-Н045Z 270 Max Lumens LED Rechargeable Headlamp User Manual
- June 9, 2024
- VIDEX
Table of Contents
VLF-Н045Z
USER’S MANUAL
TECHNICAL PARAMETERS
| | HIGH| LOW| STROBE| RED ON| RED FLASH
---|---|---|---|---|---|---
1| | 270Lm| 110Lm| 110Lm| 2.5 Lm| 2.5 Lm
4h 45min| 7h 45min| 7h| 11h| 20h
2
53m| 32m| 32m| /| /
3
700cd| 264cd| 264cd| /| /
4
5000K
5
CREE XTE 5W
6
Li-pol 1800mAh, 3.7V (built-in)
7
Micro USB, 5V 0.8A
8
3,5 h
9
IP65
10
1 m
11
70x46x38 mm
12
122 g
13
1. Output.
2. Runtime.
3. Distance.
4. Intensity.
5. Correlated color temperature.
6. LED type.
7. Compatible battery.
8. Charging port type, voltage and current.| 9. Charging time.
10. Dust and moisture protection level.
11. Impact resistance.
12. Product sizes.
13. Product weight.
14. Color: black.
15. Optical system type: optical lens
16. Materials: polyamide, polycarbonate.
---|---
MAIN FEATURES
Built-in motion sensor for swift turning on/off
Water resistance IP65 (protected from all precipitation)
Micro USB charging port
Red light preserves night vision
Rotary zooming mechanist allows you to adjust a diameter and intensity of the
light beam.
INCLUDED
- Headlamp VLF-H045Z;
- Charging cable;
- Nylon headband;
- User’s manual.
LIGHTING MODES
High – main light maximum brightness
Low – main light minimum brightness
Strobe – main light fl ashing light
Red on – constant red light
Red flash – flashing red light
OPERATING INSTRUCTION
Short press button – turn on the light, switch between modes and turn off the
light cyclically.
Note. The modes selection performs within 5 seconds. After this time, the
next short press will turn the light off . The headlamp automatically memorizes
the last selected lighting mode and applies it next time when turned on.
Short press button with the light switched off – activate the sensor HIGH
mode. After that, you can turn on/off the light by a hand waves closely to the
device
Short press button with the light switched on – remember current lighting mode
and later switch it on/off by the sensor.
BATTERY STATUS INDICATION
Press and hold the button for 0.5 seconds to see the battery status. The
indication will last for 2 seconds. The battery status is also continuously
displayed when the light is turned on.
5 divisions – ≤100% charge;
4 divisions – ≤80% charge;
3 divisions – ≤60% charge;
2 divisions – ≤40% charge;
1 division – ≤20% charge;
1 division flashes – battery discharged.
CHARGING
Plug the USB-A socket of the charging cable into electrical outlet.
Switch off the light, open the protective cover and connect the charging cable
to the fl ashlight port.
When charging, the divisions fl ash indicating the current battery level.
When fully charged, all 5 indicator bars are constantly on.
After a full charge, unplug the charging cable and close the protective cover
to prevent water and dust from entering to the headlamp body.
© The original rechargeable batteries are supplied charged and can be used
immediately after purchase, however it is recommended that the battery be
fully charged before first use. The battery needs to be charged in time before
it is completely discharged. During long periods of storage, it is recommended
to keep the battery charging level at about half capacity to extend its
service life.
MAINTENANCE AND SAFETY INSTRUCTIONS
- ATTENTION. Avoid direct shining into eyes as it may cause the eyes damage.
- Do not disassemble the sealed body of the headlamp as this may compromise performance and void the warranty.
- Keep out of the reach of children.
WARRANTY
The warranty for the headlamp is 2 years. The warranty does not cover
accessories. The LED source and the battery inside the headlamp are not
replaceable. If the LED or the battery fails, the whole headlamp should be
replaced. During the warranty period, a faulty headlamp can exchanged or
returned with a prove of purchase and all accessories saved.
The following does not apply with the scope of limited warranty:
– Misuse the product and cause the products integral components damage;
– Unauthorized disassemble or the presence of deep mechanical damage to the
product;
– Damage due to force majeure.
ENVIRONMENTAL PROTECTION
**** Pursuant to the provisions of the WEEE Act, it is forbidden to put waste
equipment marked with the symbol of a crossed bin together with other waste.
The user, wishing to get rid of electronic and electrical equipment, is
obliged to return it to a waste equipment collection point. There are no
hazardous components in the equipment that have a particularly negative impact
on the environment and human health.
The producer shall not be responsible for any damage resulting from the
failure to follow above instructions. The producer reserves the right to make
updates of this user’s manual.
Producer/Producent: Allegro Opt Sp. z o.o., Handlowa 23, 05-120 Legionowo,Poland. Made in P.R.C.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>