KUZCO EW32112 LED Exterior Wall Sconce User Guide
- June 4, 2024
- KUZCO
Table of Contents
KUZCO EW32112 LED Exterior Wall Sconce
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) type of dimmer for dimming application
- 120V input
Technical Support: 1-855-855-8926
INSTALLATION
- Remove the fixture from its original packaging
- Separate the mounting plate (1c) from the canopy (2a) by removing the set screws (2f) with the Allen key
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in the hardware package
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package
- Secure canopy (2a) to mounting plate (1c) with set screws (2f) and Allen key
- To prevent moisture from entering the outlet box and causing a short, seal around the top and side perimeter between the fixture and the wall surface with weather-resistant caulking (see illustration 1). The space at the bottom should be left un-caulked to prevent moisture build-up.
CONTACTS
- ADDRESS: 19054 28th Avenue Surrey, BC Canada V3Z 6M3
- T: 604 538 7162
- TF: 1-855 85 KUZCO
- F: 604 538 7196
- W: kuzcolighting.com
- 20210824
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>