Ningtech T6 Tire Pressure Monitoring System User Guide
- June 27, 2024
- Ningtech
Table of Contents
Ningtech T6 Tire Pressure Monitoring System
Products Specification
- Anti-theft sensor
- Waterproof and dust-proof
- Battery replaceable
- Each sensor has an individual ID
- High sensitivity
- Long transmission distance
System Components
Sensor Installation
NOTE
- Please match the sensors with monitor according to the monitor users’ manual before installation.
- Label the sensors with the number sticker provided in the accessories pack according to the instructions below.
- There will be alert on monitor when the sensor is low battery. Please replace a new CR1632 battery for safe driving.
- Test the sensors with soap bubbles after installation to check if there is leakage.
Sensor Installation
NOTE: Please turn on the monitor before sensor installation for swift signal transmission.
Battery Replacement
- Use the wrench provided to put on the sensor valve as below. Then screw off the sensor valve anticlockwise and open the battery cap.
- Take out the battery from battery pool.
- Install a new CR1632 battery inside the battery pool, and make sure the positive pole is upside.
- Put back the battery cap and tighten the cap with the wrench clockwise.
NOTE: Replace a new waterproof 0-ring from the accessory pack if it’s
broken. 
Specification
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>