Z-Lite 521PHBS Broughton 24 Inch Tall 4 Light Outdoor Pier Lamp Instruction Manual
- June 16, 2024
- Z-Lite
Table of Contents
521PHBS Broughton 24 Inch Tall 4 Light Outdoor Pier Lamp
Instruction Manual
521PHBS Broughton 24 Inch Tall 4 Light Outdoor Pier Lamp
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING
ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
GENERAL You don’t need special tools to install this fixture. Be sure to
follow the steps in the order given. Under no circumstances should a fixture
be hung on house electrical wires, nor should a swag type fixture be installed
on a ceiling which contains a radiant type heating system. Read instructions
carefully. If you are unclear as to how to proceed, consult a qualified
electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
TAKE OFF CAGE (Fig. 1)
-
Shut off the power at the circuit breaker and remove the old fixture, including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
-
Take off the cage (H) from bottom plate(I) by loosen mounting screw(F), then take off roof (E) from cage(H) by loosen mounting screw(D). INSTALL GLASS (Fig. 2)
-
Install the glass panel into cage
Step 1: Place EVA Pad on the glass which show as Fig.1
Step 2: Put the glass from bottom cage to top
Step 3: Hold the glass by glass clip COMPLETING THE INSTALLATION (Fig.1) -
Attach the cage(H) to bottom plate(I) by mounting screws(F)
-
Install the bulb (E12 Candelabra base, not included.) in accordance with the fixture’s specification.
-
Attach the roof(E) to cage(H) by mounting screws(D)
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
Your installation is now complete. Return power to the junction box and test the fixture CONNECTINE THE WIRES (Fig.3) -
While supporting the fixture, connect the electrical wires as shown in figure 3. If your post has a ground wire (green or bare copper), connect the fixture ground wire to it. If not, consult your electrician for proper grounding. After the wires are connected, tuck them carefully inside the post (G).
-
Place the fixture onto pole, and secure with the 4 mounting screws (B)
WARNING: Be sure the electriclty to the wires you are working on Is shut
off, elther the fuse Is removed or the circuit breaker is shut off.
NOTE: Before Installlng, consult local electrical codes for wiring and
grounding requirements.
Carefully remove the fixture from the carton, and check that all parts are
included, as shown in figure. Be careful not to mlsplace any of the screws or
parts whlch are needed for Installing the fixture.
Assembly and Installation Step:
- Drill 4 holes 35mm deep for the Anchor sleeves and Insert Wood screws so they are flush with the surface.
- Place the Post of Fixture to the Base, and then secure with 3 Mounting Screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>