SLV 1005392 Worklight LED Table Lamp Instruction Manual
- June 16, 2024
- SLV
Table of Contents
INSTRUCTION MANUAL PART A
Table Lamp
1005392
1005394
1006344
1005392 Worklight LED Table Lamp
The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!
The light source is only replaceable by a professional. The control gear is not replaceable.
Technical Details are subject to change.
SLV UK
Unit E Chiltern Park
Boscombe Road, Bedfordshire
LUS5 4LT
Operating Manual PART B
Table Lamp
1005392 …94 1006344
Read manual carefully and keep for further use!
Safety advices for installation and operation.
Disregard may lead to danger of life, burning or fire!
Do not alter or modify the product.
Do not fasten anything on the product.
Do not cover the product.
Take out of service when suspecting a defect or malfunction and contact your
dealer or a qualified electrician.
Take measures that children get not harmed by the product.
If the external flexible cable or cord of this luminaire is damaged, it shall
be exclusively replaced by the manufacturer or a qualified electrician to
avoid hazard.
Do not stare into the active light source.
Additional safety advices = ****
Use as directed
Safety class I (1) **** – Connection with protective conductor.
Operate only firmly fixed on an even surface.
Operate only in dry indoor area.
Do not strain mechanically or expose to strong dirt contamination.
Admissible ambient temperature(ta): -20°C …+45°C.
Light Source
The light source of this luminaire may only be replaced by the manufacturer,
an authorized service technician or a comparable qualified person.
This product contains a light source of the energy efficiency class E.
Care / Storage
**** Disconnect product from mains and let it cool down.
Clean external surfaces regularly with a slightly moistened (water) cloth.
Store dry and clean.
Installation
It is recommended to assemble the product in a lying position.
Install as shown in the figure.
Putting into service
Connect mains plug with mains plug socket.
Motion Sensor
After 30 min. of no motion detection the brightness is reduced to 30%.
After another 30 min. of no motion detection the light is switched off.
As soon as a motion is detected the light switches to the adjusted brightness.
Daylight Control
When the daylight control is running, the light keeps the adjusted brightness
on the illuminated surface regardsless of the surrounding light.
**** Check for secure standing and proper function!
© 27.10.2022 SLV GmbH, Daimlerstr. 21-23, 52531 Übach-Palenberg, Germany, Tel. +49 (0)2451 4833-0. Made in China.