beper P102FRU500 Blender User Guide
- June 4, 2024
- beper
Table of Contents
BLENDER
Blender Use Instructions
Cod.: P102FRU500
For further information and/or for instructions for use in other languages, please visit: beper.com
Precautions
Read the following instructions carefully, since they give you useful safety
information about installation, use, and maintenance and help you avoid
mishaps and possible accidents. Remove the packing and make sure that the
appliance is intact, with special attention to the supply cable. The elements
of the packing (plastic bags, polystyrene, etc) do not have to be accessible
to the children, in order to preserve them from dangerous sources. It is
recommended not to throw these packing materials in domestic waste, but to
deliver them to the appropriate station of collection or destruction refusals,
asking eventually information from the manager of the Sanitation Department of
your own municipality. If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent, or similarly qualified persons in order
to avoid a hazard. Before connecting the appliance make sure that the mains
voltage corresponds to the data specified on the label. The appliance can be
damaged if the voltage is not correct. If the plug does not suit the socket,
let it be replaced with another suitable plug by qualified personnel only,
which shall also ensure that the section of the socket cables is suitable for
your appliance’s power absorption. Generally, the use of adaptors of multiple
plugs and/or extensions is not recommended; should they be necessary, please
use only simple or multiple adaptors and extensions in compliance with the
safety rules in force, making sure that the capacity absorption limit marked
on the simple adaptors and the extensions and the maximum power limit marked
on the multiple adaptors are not exceeded. Do not use the appliance if the
cable or the plug shows any damage. Do not use the appliance after a possible
irregular working. In this case, switch it off and do not break it open. Refer
to an authorized Beper after-sale service for repair and require original
spare parts only. Failing to follow these instructions may impair the safety
of your appliance. This appliance is to be destined for its special purpose
only. Any other use is to be considered improper and thus dangerous. The
manufacturer cannot be responsible for any damages deriving from impro- per,
wrong or incautious use.
This appliance is for household use only. To protect against electric shock,
do not immerse the cord, plug, or any parts of the appliance into water or
other fluids. Do not use the appliance near explosives, highly flammable
materials, gases, or burning flames.
Do not allow children, disabled people, or people without experience or
technical ability to use the appliance if they are not properly watched over.
Close supervision is necessary when any appliance is used by or near children.
Use advice
When using the appliance make sure to stand it on a horizontal surface.
Do not use the appliance in a continuous way for more than 1 minute.
Wait for another 1 minute before switching on again the appliance. The intern
blades are very sharpen; be careful and manipulate the blades carefully. Do
not touch parts of the ppliance when moving.
Do never let the appliance work without supervision.
Do not try to remove the mixture from the bowl when the blades are moving.
Always wait for a complete stop. Do never immerge the motor, plug or supply
cord into water or other liquids.
For cleaning use a wet cloth.
Components Fig.A
- Cap
- Jar lid
- Graduated jar
- Blades
- Motor unit
- Speed selector (PULSE 0,1,2)
Instruction for use
Make sure the appliance is plugged in and the speed selector is on position
“0”. Put the graduated jar on the motor unit in the correct way.
Cut fruits and vegetables into pieces and put the ingredients into the jar
with wate r or milk. Do not exceed themaximum capacity of the jar, that is to
say, 1500ml.
Put the cap on the lid. Place the lid on the jar. Plug the blender to the
socket. Switch on the blender by pressing the speed selector in position
“Pulse”, position “1” for low speed, and speed “2” for high speed.
When finished and desired consistence is obtained, switch off the blender by
pressing the speed selector in posi- tion “0” and unplug it from the socket.
Cleaning
It is recommended to clean the blender after use, as follows :
Pour warm water with dish detergent into the jug, and turn on the blender at
speed “2” for 30 seconds. Disconnect the jug from the motor housing, empty it
and rinse thoroughly. Do not use detergents or abrasive cloth that could
damage the blender. The motor unit and the supply cord must be cleaned only
with a wet cloth. Make sure the blender and all parts are dry before for next
use.
Technical data
Power 500W
Power supply 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve
the product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed
of in the normal unsorted municipal waste stream. Old appliances must be
collected separately in order to optimize the recovery and recycling of the
materials they contain and reduce the impact on human health and the
environment. The crossed-out “wheeled bin” symbol on the product reminds you
of your obligation, that when you dispose of the appliance, it must be
separately collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of original
purchase, a 24-month guarantee applies to material and production defects. The
purchase receipt and the guarantee certificate must be submitted together in
case of a claim to guarantee. The guarantee is valid only with a guaranty
certificate and proof of purchase (fiscal receipt) indicating the date of
purchase and the model of the appliance
For any technical assistance, please contact directly the seller or our head
office in order to preserve the appliance’s efficiency and NOT void the
guarantee. Any intervention on this appliance by non-authorized persons will
automatically void the guarantee.
GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or
production during the period of guarantee, we guarantee repair free of charge
on the condition that:
– The appliance has been used properly and for the purpose for which it has
been intended.
– The appliance has not been tampered with, otherwise, it is not maintainable.
– The purchase receipt shall be presented.
– The appliance showing fair wear and tear shall not be covered by this
guarantee.
Therefore, any part that could be accidentally broken or has visible signs of
use in consumable products (such as lamps, batteries, heating elements…) the
aesthetic parts are excluded from the guarantee, and any defect whatsoever
resulting from non-respect of the rules for use, negligence in usage, and/or
maintenance of the appliance, carelessness, wrong or improper installation,
damage during transport, and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the
appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is
an accessory and/or a detachable part of the product, Beper reserves the right
to replace only the very part in a question and not the entire product Contact
your distributor in your country or after sales department Beper.
E-mail assistenza@beper.com which will forward
your inquiries to your distributor.
BEER SRL
Via Salieri, 30 – 37050 – Vallese di Oppeano – Verona
Tel. 045/7134674 – Fax 045/6984019
beper.com
CUSTOMER CARE
BEER
http://customercare.beper.com/support/home
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>