beper BP.720 Electric Tomato Juicer Instruction Manual

: June 3, 2024
: beper

Table of Contents

Safety Precaution
Description of the product
Introduction
Assembling
Use
Techincal data
GUARANTEE CERTIFICATE
GUARANTEE CONDITIONS
Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

beper BP.720 Electric Tomato Juicer Instruction Manual

Safety Precaution

Read the following instructions carefully, since they give you useful safety information about installation, use and maintenance and help you avoid mishaps and possible accidents.

Remove the packing and make sure that the appliance is intact, with special attention to the supply cable.
The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from danger sources.
It is recommended not to throw these packing material in the domestic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually information to the manager of the Sanitation Department of your own municipality.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Before connecting the appliance make sure that the mains voltage corresponds to the data specified on the label.
The appliance can be damaged if the voltage is not correct.
If the plug does not suit the socket, let it be replaced with another suitable plug by qualified personnel only, which shall also ensure that the section of the socket cables is suitable for your appliance power absorption.
Generally, the use adaptors multiple plugs and/or extensions is not recommended; should they be necessary, please use only simple or multiple adaptors and extensions in compliance with the safety rules in force, making sure that the capacity absorption limit marked on the simple adaptors and the extensions and the maximum power limit marked on the multiple adaptor are not exceeded.
Do not use the appliance if the cable or the plug shows any damages.
Do not use the appliance after a possible irregular working. In this case, switch it off and do not break it open. Refer to an authorized
Beper after-sale service for repair and require original spare parts only. Failing to follow these instructions may impair the safety of your appliance.
This appliance is to be destined to its special purpose only. Any other
use is to be considered as improper and thus dangerous.
The manufacturer cannot be responsible for any damages deriving from improper, wrong or incautious use.
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable materials, gases or burning flames.

Do not allow children, disabled people or every people without experience or technical ability to use the appliance if they are not properly watched over.
Close supervision is necessary when any appliance used by or near children.

Description of the product

Product Overview

Switch/Reverse button
Body
Fasten button
Working tube inlet
Food pusher
Plate
Working tube
Gasket
Auger
Cover locking ring
Adjustment nut
Filter holder
Filter

Introduction

This appliance is equipped with a thermostat system. This system will automatically cut off the power supply to mthe appliance in case of overheating.
If you appliance suddenly stops running proceed as follows:

Switch off the appliance.
Unplug from the socket.
Let the appliance cool down for 60 minutes.
Put the mains plug in the socket.
Switch the appliance on again.

Caution: In order to avoid a hazardous situation, this appliance must never be connected to a time switch.

Before cleaning and /or assembling the appliance, switch the appliance off and remove the plug from the socket.

Assembling

Place the auger into the working tube, long end first, and turn to feed the auger slightly until it is set into the working tube.(Fig.B1)
Place the filter into the tube around to the auger. (Fig.B1) Make sure that the metal part is facing downwards.
Place the cover locking ring and the adjustment nut into the working tube, and slightly turn counterclockwise.
Insert the working tube so composed in the working tube inlet, by pressing the fasten button and then turning it slightly counterclockwise to fasten it to the body.
Put the plate on the top of the working tube.(Fig.B3)
Put a cup under the adjustment nut to collect the tomato juice, and a cup under the working tube for tomato sediment, as shown on the image.(Fig.B3)

Use

Wash all part as suggested before the first use, and always immediately after each use.
Insert the plug into the socket and press the switch button on.
Place the tomatoes inside the tray and press them with the food pusher.
Don’t press strongly .
Don’t fill the tray too much

Caution: use only food pusher to press the tomatoes.

Cleaning
Remove any remaining part of tomatoes. Wash all accessories with warm water and some soap than dry them mcarefully. Clean the body of the appliance with a damp cloth than dry them carefully. Never use solvent or alcoholic solution that may cause damages to the appliance. Never immerse the appliance into the water.

Never use washingmachine

Techincal data

Power: 300W
Power supply: 220-240V~ 50/60Hz

For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.

The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.

GUARANTEE CERTIFICATE

This appliance has been checked in the factory. From the date of original purchase a 24 month guarantee applies to material and production defects. The purchase receipt and the guarantee certificate must be submitted together in case of claim to guarantee.

The guarantee is valid only with a guaranty certificate and proof of purchase (fiscal receipt) indicating the date of purchase and the model of the appliance.

For any technical assistance, please contact directly the seller or our head office in order to preserve the appliance’s efficiency and NOT TO void the guarantee. Any intervention on this appliance by non-authorized persons
will automatically void the guarantee.

GUARANTEE CONDITIONS

If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:

The appliance has been used properly and for the purpose for which it has been intended.
The appliance has not been tampered with, otherwise it is not maintainable.
The purchase receipt shall be presented.
The appliance showing a fair wear and tear shall not be covered by this guarantee.

Therefore, any part that could be accidentally broken or having visible signs of use in consumable products (such as lamps, batteries, heating elements…) the aesthetic parts are excluded from the guarantee, and any defect whatsoever resulting from non-respect of the rules for use, negligence in usage and/or maintenance of the appliance, carelessness, wrong or improper installation, damage during transport and any other damage not attributable the supplier.

For every defect that could not be repaired within the guarantee period, the appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is an accessory and/or a detachable part of the product, Beper reserves the right to replace only the very part in question and not the entire product

Contact your distributor in your country or after sales department Beper.
E-mail assistenza@beper.com which will forward your enquiries to your distributor.