beper P206ZAN110 Solar Lantern Bug Zapper Instruction Manual
- June 3, 2024
- beper
Table of Contents
beper P206ZAN110 Solar Lantern Bug Zapper
General safety advice
Read the operating instructions carefully before first use of the
appliance.
Read the following instructions carefully, since they give you useful
safety information about installation, use and maintenance and help you avoid
mishaps and possible accidents.
Remove the packing and make sure that the appliance is intact. The elements of
the packing (plastic bags, polystyrene, etc) do not have to be accessible to
the children, in order to preserve them from danger sources.
It is recommended not to throw these packing material in the domestic waste,
but to deliver them to the appropriate station of collection or destruction
refusals, asking eventually information to the manager of the Sanitation
Department of your own municipality.
This appliance is to be destined to its special purpose only. Any other use is
to be considered as improper and thus dangerous.
The manufacturer cannot be responsible for any damages deriving
from improper, wrong or incautious use.
Do not expose the appliance to atmospheric agents such as rain, wind, snow,
hail.
Do not use the appliance near explosives, highly flammable materials, gases,
burning flames, heaters.
Do not allow children, disabled people or every people without experience or
technical ability to use the appliance if they are not properly watched over.
Close supervision is necessary when any appliance used by or near children.
Also make any dangerous parts unserviceable, especially for children who
could play with the appliance.
Warnings for use
Read the following instructions carefully before using the appliance.
Before and during the use of the appliance, it is necessary to follow some
elementary precautions.
Do not use the appliance in case of visible damage or malfunctioning; contact
professionally qualified personnel for assistance.
This appliance is to be destined to its special purpose only. Any other use is
to be considered as improper and thus dangerous; this appliance is only
intended for domestic use.
This device cannot be used by children, or persons with reduced physical,
sensitive or intellectual capabilities, or with lack of experience and
knowledge, without supervision or if they are not given instructions and
warnings on the correct and safe use of the device and the potential risks
related to its use.
Keep the product and all packaging materials out of the reach of children; do
not let children play with the product and/or its packaging.
Do not use the appliance in locations where flammable vapor or explosive dust
is likely to exist.
Keep the appliance away from water. Do not immerse in water. Do not use the
appliance with wet hands/feet.
Do not attempt to damage or tamper in any way with the protective metal grid.
Do not insert any foreign object (pencils, crayons, sticks, fingers, etc.)
into the metal grid when the appliance is working.
Warning: do not touch the grid when the item is on; electric shock hazard
Product description Fig. A
- Solar panel
- External plastic grid
- Cover of the internal grid
- Internal grid
- Selector/Ignition button
- Bas
- Battery compartment
First use
To ensure the battery reaches its maximum charge capacity, the bug zapper
needs to be exposed to sunlight for 8 to 12 consecutive hours.
If after 8-12 hours of exposure to sunlight, the bug zapper does not turn on,
check that the battery is correctly positioned, and that the bug zapper is in
a very sunny position and not in the shade.
The bug zapper can be used both as a lamp and as a bug zapper simply by moving
the selector to the desired position (Fig. A point 6). If the selector is
positioned on “OFF” the bug zapper will stay off, positioned on “Light” it
will work only as a lamp, on “UV” it will work as a bug zapper.
Warning: The internal grid produces an electric discharge capable to kill
insects.
Do not touch the internal grid even when the bug zapper is off in order to
avoid small shocks. Keep away from children.
Battery installing and replacement
Firmly hold the external plastic grid and turn it counter clockwise, in order
to unscrew the top cover where the solar panel is installed.
Turn the inner grid cover counter clockwise so that it can be removed.
Place the selector / ignition button in the “OFF” position.
Caution: Be careful not to touch the internal grid.
Lift the battery compartment cover by using the appropriate button, then install the battery provided with the bug zapper, making sure to respect the polarity indicated inside the compartment.
battery provided with the bug zapper, making sure to respect the polarity
indicated inside the compartment.
Put the battery compartment cover and the inner grid cover back in place;
select the desired function then reposition the top where the solar panel is
installed, then place the bug zapper in sunlight.
In case battery needs to be replace, replace it with one of the same type,
following the instructions above.
Tips for winter season
During winter, make sure that the top solar panel is free from snow and ice in
order to allow the battery to recharge.
In case of snowing, it is recommended to set the switch to “OFF”.
If the product is covered by snow for a long period of time, wait until the
snow has completely melted and let the battery charge for at least 12 hours.
Cleaning and maintenance
Before proceeding with any cleaning and/or maintenance operation, turn the bug
zapper off.
Gently clean the internal metal grid with a soft brush to remove any
electrocuted insects.
Clean the outside grid using a soft, slightly damp cloth.
Do not use metal objects to clean the internal grid, to prevent from damaging
it.
Do not immerse the bug zapper in water and/or other liquids.
Make sure all parts are dry before turning the bug zapper back on.
Technical data
Power supply: Ni-Mh AA 300mAh 1.2V (included)
For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed
of in the normal unsorted municipal waste stream. Old appliances must be
collected separately in order to optimize the recovery and recycling of the
materials they contain, and reduce the impact on human health and the
environment.
The crossed out “wheeled bin” symbol on the product reminds you of your
obligation, that when you dispose of the appliance, it must be separately
collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of original purchase a 24 month guarantee applies to material and production defects. The purchase receipt and the guarantee certificate must be submitted together in case of claim to guarantee.
The guarantee is valid only with a guaranty certificate and proof of purchase (fiscal receipt) indicating the date of purchase and the model of the appliance
For any technical assistance, please contact directly the seller or our head office in order to preserve the appliance’s efficiency and NOT TO void the guarantee. Any intervention on this appliance by non-authorized persons will automatically void the guarantee.
GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:
- The appliance has been used properly and for the purpose for which it has been intended.
- The appliance has not been tampered with, otherwise it is not maintainable.
- The purchase receipt shall be presented.
- The appliance showing a fair wear and tear shall not be covered by this guarantee.
Therefore, any part that could be accidentally broken or having visible signs
of use in consumable products (such as lamps, batteries, heating elements…)
the aesthetic parts are excluded from the guarantee, and any defect whatsoever
resulting from non-respect of the rules for use, negligence in usage and/or
maintenance of the appliance, carelessness, wrong or improper installation,
damage during transport and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the
appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is
an accessory and/or a detachable part of the product, Beper reserves the right
to replace only the very part in question and not the entire product
Contact your distributor in your country or after sales department Beper.
E-mailassistenza@beper.com which will forward your enquiries to your distributor.
YOU MIGHT ALSO LIKE
Fly Swatter Cod.: P206ZAN200
Stainless steel grill Power supply: 2 x AA
beper.com
Fly Repelling Fan
Cod.: P206ZAN300
Drive away flies by turning the reflective blades
It can be used both in support and hanging, thanks to the practical hook on
the bottom USB cable (included)
Works with 2 AA batteries (not included)
beper.com
BEPER SRL
Via Salieri, 30 – 37050 – Vallese di Oppeano – Verona
Tel. 045/7134674 – Fax 045/6984019 beper.com
CUSTOMER CARE BEPER
Documents / Resources
|
beper P206ZAN110 Solar Lantern Bug
Zapper
[pdf] Instruction Manual
P206ZAN110 Solar Lantern Bug Zapper, P206ZAN110, Solar Lantern Bug Zapper,
Lantern Bug Zapper, Bug Zapper
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>