beper 50.245 USB Rechargeable Lint Remover User Manual

: June 3, 2024
: beper

Table of Contents

50.245 USB Rechargeable Lint Remover
Operation
**Cleaning
Technical data
Documents / Resources

USB RECHARGEABLE LINT REMOVER
User Manual

50.245 USB Rechargeable Lint Remover

For further information and/or for instructions for use in other languages , please visit: beper.com
Precautions
Read the following instructions carefully, since they give you useful safety information about installation, use and maintenance and help you avoid mishaps and possible accidents.
Remove the packing and make sure that the appliance is intact. The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from danger sources. It is recommended not to throw these packing material in the domestic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually information to the manager of the Sanitation Department of your own municipality.
This appliance is to be destined to its special purpose only.
Any other use is to be considered as improper and thus dangerous. The manufacturer cannot be responsible for any damages deriving from improper, wrong or incautious use.
Do not expose the appliance to atmospheric agents such as rain, wind, snow, hail.
Do not use the appliance near explosives, highly flammable materials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without experience or technical ability to use the appliance if they are not properly watched over. Close supervision is necessary when any appliance used by or near children.
Also make any dangerous parts unserviceable, especially for children who could play with the appliance.
Some warnings
Do not charge the appliance for more than 24 hours continuously.
Do not charge the appliance at temperatures below 0°C or above 40°C, otherwise it will shorten the battery life.
Never wash the appliance’s body with water or other liquids.
If an abnormal smell of burns will occur when the product is charging please immediately cut off the power.
If you will not use the appliance for long time store it dry and clean.

Operation

Before charging, please make sure the switch is off.
Insert the small USB charging plug into the slot placed on the handle of the appliance, and insert the big USB plug into a charging source (Computer, adapter…).
When the appliance is on charge, the indicator light placed on the ON/OFF switch will light up. Let the appliance charge for 6-8 hours, after charging is completed, disconnect the charging cable.
Please take away the protector lid pulling to the top, switch to ON (I) position and the appliance will start operate.
The appliance must be used to remove unsightly hair, lint and wool balls from skirts, sweaters, jackets, trousers, blankets or other clothing in general.
Warning: do not remove the lint directly from the garments while wearing.
Pay attention to buttons, zips, signs, stitching and other elements in the garment.
It is advisable to make a test by passing the lint remover into invisible parts of the garment.
Gently wipe the lint remover on the surface of the garments one or more times until completely smoothed.
If the fabric is very light, it is advisable to fold it into two parts before removing the lint.
Note: It is advisable to pass the lint remover on the fabrics by following the weave of the fabric itself.

**Cleaning

**

(fig. A-B-C)
Before cleaning the lint remover make sure it is turned off and unplugged.
Remove the protector lid by pulling it to the top.
Remove the plastic ring by turning anti-clockwise (FIG.A)
Remove the metal ring by turning anti-clockwise (FIG.B)
Use the equipped cleaning brush to clean the lint removed (FIG.C)
Warning: it is recommended not to touch the blades because you could be injured.
At the end assemble the components again following steps 2 and 1 in reverse order, making sure to rotate clockwise.
Attention: the product is equipped with a safety system that will not let operate the product if the components will not be positioned correctly.

Technical data

Ni-Mh rechargeable battery
USB power supply: 5V
For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on hu- man health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of original purchase a 24 month guarantee applies to material and production defects. The purchase receipt and the guarantee certificate must be submitted together in case of claim to guarantee.
The guarantee is valid only with a guaranty certificate and proof of purchase (fiscal receipt) indicating the date of purchase and the model of the appliance
For any technical assistance, please contact directly the seller or our head office in order to preserve the appliance’s efficiency and NOT TO void the guarantee. Any intervention on this appliance by non-authorized persons will automatically void the guarantee.
GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:

The appliance has been used properly and for the purpose for which it has been intended.
The appliance has not been tampered with, otherwise it is not maintainable.
The purchase receipt shall be presented.
The appliance showing a fair wear and tear shall not be covered by this guarantee.

Therefore, any part that could be accidentally broken or having visible signs of use in consumable products (such as lamps, batteries, heating elements…) the aesthetic parts are excluded from the guarantee, and any defect whatsoever resulting from non-respect of the rules for use, negligence in usage and/or maintenance of the appliance, carelessness, wrong or improper installation, damage during transport and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is an accessory and/or a detachable part of the product, Beper reserves the right to replace only the very part in question and not the entire product
Contact your distributor in your country or after sales department Beper.
E-mail assistenza@beper.com which will forward your enquiries to your distributor.
CUSTOMER CARE BEPER

http://customercare.beper.com/support/home

BEPER SRL
Via Salieri, 30 – 37050
Vallese di Oppeano – Verona
Tel. 045/7134674 – Fax 045/6984019
beper.com
Cod.: 50.245

Documents / Resources

| beper 50.245 USB Rechargeable Lint Remover [pdf] User Manual
50.245, USB Rechargeable Lint Remover, 50.245 USB Rechargeable Lint Remover, Rechargeable Lint Remover, Lint Remover, Remover
---|---