beper 40.821 Keep Calm Digital Weighing Scales User Manual
- June 3, 2024
- beper
Table of Contents
beper 40.821 Keep Calm Digital Weighing Scales
Instruction
General safety advice
Read the operating instructions carefully before first use of the appliance.
Read the following instructions carefully, since they give you useful safety
information about installation, use and maintenance and help you avoid mishaps
and possible accidents.
Remove the packing and make sure that the appliance is intact, with special
attention to the supply cable. The elements of the packing
(plastic bags, polystyrene, etc) do not have to be accessible to the children,
in order to preserve them from danger sources.
It is recommended not to throw these packing material in the domestic waste,
but to deliver them to the appropriate station of collection
or destruction refusals, asking eventually information to the manager of the
sanitation department of your own municipality.
This appliance is to be destined to its special purpose only.
Any other use is to be considered as improper and thus dangerous. The
manufacturer cannot be responsible for any damages deriving from improper,
wrong or incautious use.
To avoid any heating risk, it is recommended to unroll completely the supply
cord and to unplug the appliance, when not used.
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any parts of
the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain, wind, snow,
hail.
Do not use the appliance near explosives, highly flammable materials, gases,
burning flames, heaters.
Do not allow children, disabled people or every people without experience or
technical ability to use the appliance if they are not properly watched over.
Close supervision is necessary when any appliance used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unserviceable by
simply cutting the supply cable after disconnecting the plug from the socket.
Also make any dangerous parts unserviceable, especially for children who could
play with the appliance.
Setting
Remove the scale from the packaging.
Turn the balance upside down carefully, and open the battery cover.
Remove the transparent film of the batteries.
Close the battery compartment cover.
Caution: Discharged batteries become dangerous for the possible loss of electrolyte fluid that is very corrosive. To avoid damage to the appliance caused by this possibility, replace the exhausted batteries without delay. Remember to remove the batteries when you are not going to use the balan-ce for a long time. Damages caused by battery liquid are not recognized.
Battery replacement
When the scale does not turn on or displays “Lo” it means that the batteries
are exhausted. Replace them with
new ones.
Carefully, turn the balance upside down, so that the bottom of the scale is
accessible.
Press the battery compartment in the direction indicated by the arrow and open
the cover by tapping it.
Insert the batteries into the compartment according to the correct polarity.
Pay attention to the correct polarity of the connection. Incorrect
installation can damage the scale.
Close the cover and then turn the scale back on.
Operation
The scale is equipped with a shock-sensitive switch. Give a slight touch on
the platform to light the scale itself.
When the display turns on, get on the scale with both feet, hold them in the
glass surface as much as possible and stay still for a few seconds.
The display will automatically display the corresponding weight automatically;
after approx. 10 seconds, the display will automatically reset.
The scale automatically shuts off after 10 seconds of inactivity.
The scale weights up to 180 kg. To avoid any damage, if the “oL” message
appears on the display immediately get off from the scale as it indicates it
is beyond the weighing limit.
Body weight is subject to changes during the day, so there may be weight
differences.
Small changes in weighing are usually normal.
The scale is a precise tool and is very sensitive to movement of the body. For
better precision: get on the scale, relax your body, hold your head firm and
stay still.
Note: there is a small switch near the battery compartment to switch the
weight from kg to lb.
Cleaning the scale
The scale can be cleaned with a soft cloth, slightly dampened in warm water.
Never clean with diluents, abrasive products in general; these could damage
the surface of the scale.
Do not immerse the scale in water.
Protect from liquid infiltration.
Keep away the scale from hair shampoos or preparations, cosmetics or bath
solutions; they can cause damage to the aesthetic parts and internal scale
circuit.
Technical data
Power supply: lithium 1xcr2032 (included)
For any improvement reasons, Beper reserves the right to modify or improve the
product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of original
purchase a 24 month guarantee ap-plies to material and production defects. The
purchase receipt and the guarantee certificate must be submitted together in
case of claim to guarantee.
The guarantee is valid only with a guaranty certificate and proof of purchase
(fiscal receipt) indicating the date of purchase and the model of the
appliance
For any technical assistance, please contact directly the seller or our head
office in order to preserve the appliance’s efficiency and NOT TO void the
guarantee. Any intervention on this appliance by non-authorized persons will
automatically void the guarantee.
GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or
production during the period of guarantee, we guarantee repair free of charge
on condition that:
- The appliance has been used properly and for the purpose for which it has been intended.
- The appliance has not been tampered with, otherwise it is not maintainable.
- The purchase receipt shall be presented.
- The appliance showing a fair wear and tear shall not be covered by this guarantee.
Therefore, any part that could be accidentally broken or having visible signs of use in consumable products (such as lamps, batteries, heating elements…) the aesthetic parts are excluded from the guarantee, and any defect whatsoever resulting from non-respect of the rules for use, negligence in usage and/or maintenance of the appliance, carelessness, wrong or improper installation, damage during transport and any other damage not attributable the supplier. For every defect that could not be repaired within the guarantee period, the appliance will be replaced free of charge. In any case, if the part to be replaced for defect, breakage or malfunction is an accessory and/or a detachable part of the product, Beper reserves the right to replace only the very part in question and not the entire product Contact your distributor in your country or after sales department Beper. E-mail assistenza@beper.com which will forward your enquiries to your distributor.