beper P301PIS100 Hair Dryer and Volumizer Hot Air Brush Instruction Manual
- June 3, 2024
- beper
Table of Contents
beper P301PIS100 Hair Dryer and Volumizer Hot Air Brush
Precautions
Read the following instructions carefully, since they give you useful safety information about installation, use and maintenance and help you avoid mishaps and possible accidents.
- Remove the packing and make sure that the appliance is intact, with special attention to the supply cable.
- The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from danger sources. It is recommended not to throw these packing material in domestic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually information to the manager of the Sanitation Department of your own municipality.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Before connecting the appliance make sure that the mains voltage corresponds to the data specified on the label.
- The appliance can be damaged if the voltage is not correct.
- If the plug does not suit the socket, let it be replaced with another suitable plug by qualified personnel only, which shall also ensure that the section of the socket cables is suitable for your appliance power absorption.
- Generally, the use adaptors with multiple plugs and/or extensions is not recommended; should they be necessary, please use only simple or multiple adaptors and extensions in compliance with the safety rules in force, making sure that the capacity absorption limit marked on the simple adaptors and the extensions and the maximum power limit marked on the multiple adaptor are not exceeded.
- Do not use the appliance if the cable or the plug shows any damages.
- Do not use the appliance after a possible irregular working. In this case, switch it off and do not break it open. Refer to an authorized Beper after-sale service for repair and require original spare parts only. Failing to follow these instructions may impair the safety of your appliance.
- This appliance is to be destined to its special purpose only. Any other use is to be considered as improper and thus dangerous. The manufacturer cannot be responsible for any damages deriving from improper, wrong or incautious use.
- This appliance is for household use only.
- To protect against electric shock, do not immerse cord, plug or any parts of the appliance into water or other fluids.
- Do not use the appliance near explosives, highly flammable materials, gases or burning flames.
- Do not allow children, disabled people or every people without experience or technical ability to use the appliance if they are not properly watched over.
- Close supervision is necessary when any appliance used by or near children.
Important safety instructions
- Make sure to always unplug the appliance after every use.
- Do not immerse or drop the appliance in water.
- Do not store, use or install the appliance where there is a risk it might fall into water (e.g. sink or bathtub).
- If the appliance accidentally comes into contact with water o falls into water, unplug it immediately. Do not attempt to retrieve the appliance in the water.
- Do not use the appliance if damaged or malfunctioning, or in case the power cable and/or the plug have been damaged.
- Do not leave the appliance operating unattended.
- Do not insert any foreign object inside the openings and vent holes.
- Make sure all openings and vent holes are free from obstruction during use, and that are always free from dust and dirt.
- This appliance cannot be used by children, or persons with reduced physical, sensitive or intellectual capabilities, or with lack of experience and knowledge, without supervision or if they are not given instructions and warnings on the correct and safe use of the device and the potential risks related to its use.
- Do not use this device in a bathtub, shower, or water-filled reservoir When the hairdryer is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hairdryer is switched off.
- For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
- Do not put the appliance down while operating, make sure to always switch it off before laying it down to avoid dangerous overheating.
- Warning: do not use this appliance near bathtubs, showers, basins or other vessels containing water.
Description of product
- Temperature setting and operating switch
- Ceramic coating
- Handle
- Cold tip
- Swivel cord
Operation
Make sure the operating switch is placed on 0, and connect the plug to the wall socket. Place the operating switch on the desired setting:
- C – cool air shot, the appliance will blow out warm (not hot) air, and it will operate at the highest speed
- 1 – the appliance will operate at the lowest speed and will blow out hot air at low temperature
- 2 – the appliance will operate at the highest speed, and will blow out hot air at high temperature.
To switch the appliance off, place the operating switch on 0. It is better to
use the hot air brush on wet/damp hair, to reduce potential damage caused by
heat. For a faster drying and more efficient styling, part your hair in locks,
and slide the brush along their entire length, from roots to tips, without
dwelling too much on the same area to avoid burns and damage to the hair.
Warning: the brush blows hot air, be careful during use not to get it too
close to the scalp, to avoid burns.
To create waves and curls, it is better to dry your hair almost completely at
high temperature, and then finish your styling at the lowest temperature (use
cold air shot at the end to fix your styling).
Cleaning and maintenance
- Before proceeding with any cleaning and maintenance operation, make sure the appliance is unplugged and has completely cooled down.
- After each use, it is better to clean the bristles by removing any hair or dust that might have got caught during use.
- Do not use sharp objects, to avoid damaging the ceramic coating.
- Clean the handle with a slightly dampened, soft cloth; do not use abrasive or corrosive detergents.
Technical data
- Power: 1100-1300W
- Input: 220-240V~ 50-60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any notice. The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of original
purchase, a 24-month guarantee applies to material and production defects. The
purchase receipt and the guarantee certificate must be submitted together in
case of claim to guarantee.
The guarantee is valid only with a guaranty certificate and proof of purchase
(fiscal receipt) indicating the date of purchase and the model of the
appliance
For any technical assistance, please contact directly the seller or our head
office in order to preserve the appliance’s efficiency and NOT TO void the
guarantee. Any intervention on this appliance by non-authorized persons will
automatically void the guarantee.
GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:
- The appliance has been used properly and for the purpose for which it has been intended.
- The appliance has not been tampered with, otherwise it is not maintainable.
- The purchase receipt shall be presented.
- The appliance showing a fair wear and tear shall not be covered by this guarantee.
Therefore, any part that could be accidentally broken or having visible signs
of use in consumable products (such as lamps, batteries, heating elements…)
the aesthetic parts are excluded from the guarantee, and any defect whatsoever
resulting from non-respect of the rules for use, negligence in usage and/or
maintenance of the appliance, carelessness, wrong or improper installation,
damage during transport and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the
appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is
an accessory and/or a detachable part of the product, Beper reserves the right
to replace only the very part in question and not the entire product Contact
your distributor in your country or after sales department Beper.
E-mail assistenza@beper.com which will forward
your enquiries to your distributor.
BEPER SRL
Via Salieri, 30 – 37050 – Vallese di Oppeano – Verona
Tel. 045/7134674 – Fax 045/6984019
beper.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>