beper 40.490 Wall Mounted Hair Dryer Instruction Manual
- June 3, 2024
- beper
Table of Contents
beper 40.490 Wall Mounted Hair Dryer
Precautions
Read the following instructions carefully, since they give you useful safety information about installation, use, and maintenance and help you avoid mishaps and possible accidents. Remove the packing and make sure that the appliance is intact, with special attention to the supply cable. The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from dangerous sources. It is recommended not to throw these packing materials in the domestic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually information to the manager of the Sanitation Department of your own municipality. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Before connecting the appliance make sure that the mains voltage corresponds to the data specified on the label. The appliance can be damaged if the voltage is not correct. If the plug does not suit the socket, let it be replaced with another suitable plug by qualified personnel only, which shall also ensure that the section of the socket cables is suitable for your appliance’s power absorption. Generally, the use of adaptors with multiple plugs and/or extensions is not recommended; should they be necessary, please use only simple or multiple adaptors and extensions in compliance with the safety rules in force, making sure that the capacity absorption limit marked on the simple adaptors and the extensions and the maximum power limit marked on the multiple adaptors are not exceeded. Do not use the appliance if the cable or the plug shows any damages. Do not use the appliance after a possible irregular working. In this case, switch it off and do not break it open. Refer to an authorized Beper after-sale service for repair and require original spare parts only. Failing to follow these instructions may impair the safety of your appliance. This appliance is to be destined to its special purpose only. Any other use is to be considered as improper and thus dangerous. The manufacturer cannot be responsible for any damages deriving from improper, wrong or incautious use. This appliance is for household use only. To protect against electric shock, do not immerse cord, plug or any parts of the appliance into water or other fluids. Do not use the appliance near explosives, highly flammable materials, gases or burning flames.
Do not allow children, disabled people or every people without experience or technical ability to use the appliance if they are not properly watched over. Close supervision is necessary when any appliance used by or near children.
Warnings for use
Make sure to always unplug the appliance after every use. Do not immerse or drop the appliance in water. Do not store, use or install the appliance where there is a risk it might fall into water (e.g. sink or bathtub). If the appliance accidentally comes into contact with water o falls into water, unplug it immediately. Do not attempt to retrieve the appliance in the water. Do not use the appliance if damaged or malfunctioning, or in case the power cable and/or the plug have been damaged. Do not leave the appliance operating unattended. Do not insert any foreign object inside the openings and vent holes. This appliance cannot be used by children, or persons with reduced physical, sensitive or intellectual capabilities, or with lack of experience and knowledge, without supervision or if they are not given instructions and warnings on the correct and safe use of the device and the potential risks related to its use. Do not use this device in a bathtub, shower, or water- filled reservoir When the hairdryer is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hairdryer is switched off. For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
Warning: do not use this appliance near bathtubs, showers, basins or other vessels containing water.
Description of product Fig. A
- Hair dryer
- Wall base
- Plug
Instructions for mounting
To reduce the risk of electric shock, do not install the appliance next to
bathtubs or sinks. It is important to install the appliance at a proper
height, as it is natural for coiled electrical wire to loosen and stretch with
time.
Note: it is strongly recommended to contact qualified personnel for
installation, to avoid damages caused by the erroneous mounting of the
appliance. Lay the wall base flat against the wall, and use the holes as a
guide to find and mark the desired position for the installation Remove the
wall base and start drilling where the marks on the wall have been traced; use
a drilling tip of 6 mm or ¼”. Insert the plastic anchors into the holes Remove
the hair dryer from the wall base, and lay the wall base flat on the wall,
with holes in correspondence with the anchors, and insert the screws Fasten
clockwise until the wall base is firmly fixed and steady Insert the hair dryer
into the wall base and plug into the wall socket
Operating instruction
Ensure that the ON/OFF switch is set on 0 before plugging the appliance To
turn the appliance on, remove the hair dryer from the wall base and set the
speed on 1 or 2, based on preference To suspend the operation of the
appliance, insert the hair dryer into the wall base, leaving the ON/OFF switch
on the selected speed position; to resume operation, just remove the hair
dryer from the wall base To turn the appliance off, set the ON/OFF switch on 0
In case of sudden shut down of the appliance, immediately set the ON/OFF
switch on 0, and let the hair dryer cool for a few minutes before using again
Cleaning and maintenance
Before performing any maintenance or cleaning, ensure that the appliance is
off and unplugged from the wall socket. Do not put the appliance in water and
ensure that the plug and the power cord are always kept dry. Use a damp cloth
to clean the appliance, and wipe dry thoroughly; do not use solvents or
abrasive cleansers or detergents.
Technical data
- Power: 1700-2000W
- Input: 220-240V~ 50-60Hz
For any improvement reasons, Beer reserves the right to modify or improve the product without any notice. The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed-out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.
GUARANTEE CERTIFICATE
This appliance has been checked in the factory. From the date of the original
purchase, a 24-month guarantee applies to material and production defects. The
purchase receipt and the guarantee certificate must be submitted together in
case of a claim to guarantee. The guarantee is valid only with a guaranty
certificate and proof of purchase (fiscal receipt) indicating the date of
purchase and the model of the appliance For any technical assistance, please
contact directly the seller or our head office in order to preserve the
appliance’s efficiency and NOT TO void the guarantee. Any intervention on this
appliance by non-authorized persons will automatically void the guarantee.
GUARANTEE CONDITIONS
If the appliance shows defects as a result of faulty material and/or
production during the period of guarantee, we guarantee repair free of charge
on condition that:
- The appliance has been used properly and for the purpose for which it has been intended.
- The appliance has not been tampered with, otherwise, it is not maintainable.
- The purchase receipt shall be presented.
- The appliance showing fair wear and tear shall not be covered by this guarantee.
Therefore, any part that could be accidentally broken or have visible signs of
use in consumable products (such as lamps, batteries, and heating elements…)
the aesthetic parts are excluded from the guarantee, and any defect whatsoever
resulting from non-respect of the rules for use, negligence in usage and/or
maintenance of the appliance, carelessness, wrong or improper installation,
damage during transport and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the
appliance will be replaced free of charge. In any case, if the part to be
replaced for defect, breakage or malfunction is an accessory and/or a
detachable part of the product, Beer reserves the right to replace only the
very part in a question and not the entire product Contact your distributor in
your country or after-sales department Beer.
E-mail assistenza@beper.com which will forward
your inquiries to your distributor.
BEPER SRL
Via Salieri, 30 – 37050 – Vallese di Oppeano – Verona
Tel. 045/7134674 – Fax 045/6984019
beper.com
CUSTOMER CARE BEPER
For further information and/or instructions for use in other languages, please visit: beper.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>