SLV G9-QT14 Wall Light Instruction Manual

SLV G9-QT14 Wall Light

FEATURED

PARTS

INSTALLATION

Specifications

• Model: 1000335
• IP Rating: IP44
• Dimensions:
  • Length: 20 mm
  • Width: 6 mm
• Minimum Distance to Illuminated Surface: 0.50 m
• Maximum Length for Installation: 8 cm
• Maximum Depth for Installation: 3.5 cm
• Safety Class: I (1) – Connection with protective conductor
• Recommended Light Sources: QT14, G9, 42W max.

Product Usage Instructions

Safety Instructions

• The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations.
• Read the manual carefully and keep it for further use.
• Disregarding the safety instructions may lead to danger of life, burning, or fire.
• Any work on the electrical connection should only be performed by an electrician.
• Do not alter or modify the product.
• Do not fasten anything on the product.
• Do not cover the product.
• Operate only with intact protection glass.
• If you suspect a defect or malfunction, take the product out of service and contact your dealer or a qualified electrician.
• Take measures to ensure children are not harmed by the product.

Operating Manual PART B Wall Light

Read the manual carefully and keep it for further use!

WARNING: Safety advice for installation and operation.

• Disregarding may lead to danger of life, burning, or fire!
• Any work on the electrical connection only by the electrician.
• Do not alter or modify the product.
• Do not fasten anything on the product.
• Do not cover the product.
• Operate only with intact protection glass.
• Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician.
• Take measures that children are not harmed by the product.

Additional safety advice = WARNING

Use as directed

• Safety class I – Connection with protective conductor.
• Operate only firmly fixed on an even surface.
• Operate only on normal or not inflammable surfaces.
• Do not strain mechanically or expose to strong dirt contamination.
• The minimum distance of the light source to the illuminated surface: 0,5 m.
• IP44: Protection against foreign objects > Ø 1,0mm – Protection against
• splashing water from all directions.

Lamp replacement

WARNING: Disconnect the luminaire from the mains and let it cool down.

• Suitable light sources: QT14, G9, 42W max.
• Clean gasket when dirty.
• Tighten screws evenly and cross-wise.

Care / Storage

WARNING

• Disconnect the product from the mains and let it cool down.
• Clean external surfaces regularly with a slightly moistened (water) cloth.
• Do not clean with a pressure washer.
• Openings providing aeration or drainage must be kept free.
• The following influences may have unwanted effects on the product: acidic
• surroundings, high salt content in the air, cleaning agents, fertilizer, thawing salt, and chemicals.
• Store dry and clean.

Installation

• Switch off mains / fixed connection cable!
• Use only described accessories.
• Use only suitable fastening materials.
• Only suited for wall surface mounting.
• Note the distance to the illuminated surface.

WARNING

• Follow local regulations for outdoor installations.
• Do not seal the product yourself (e.g. with silicone).
• Install according to declared IP type.
• Install as shown in the figure.

Electrical connection

Direct the fixed wiring with its complete insulation at least 15 mm into the
housing.

• Equip wires of the fixed wiring with protective tubes.
• Equip flexible wire ends with suitable wire ferrules!
  • Live conducto r → Terminal L
  • Neutral conductor → Terminal N
  • Protective conductor → Earth terminal

FAQ

FAQ (Frequently Asked Questions)

• Q: Who should install this product?
  • A: The installation should be carried out only by an approved electrician under consideration of local and national regulations.
• Q: What light sources are recommended for this product?
  • A: The recommended light sources are QT14, and G9, with a maximum power of 42W.
• Q: How should I clean the product?
  • A: Clean external surfaces regularly with a slightly moistened (water) cloth. Do not clean with a pressure washer.
• Q: How should I store the product?
  • A: Store the product in a dry and clean place, avoiding exposure to acidic surroundings, high salt content in the air, cleaning agents, fertilizer, thawing salt, or chemicals.

WARNING: Check secure fixation and proper function!
© 13.03.2023 SLV GmbH, Daimlerstr. 21-23, 52531 Übach-Palenberg, Germany,
Tel. +49 (0)2451 4833-0. Made in China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>