EUROLAMP 147-29170 Stand Quartz Heater User Manual
- June 15, 2024
- EUROLAMP
Table of Contents
QUARTZ HEATER
STAN
HCH – 2000DI
220-240V~ 50/60Hz 2000W
147-29170
INTRODUCTION
Thank you for purchasing this infrared heater. We hope you will be completely
satisfied with this product. To ensure this, please read these instructions
carefully before use and keep them in a safe place.
WARNINGS
– This electrical appliance complies with technical safety and electromagnetic
compatibility standards.
– Never touch your heater when in operation (risk of burns).
– Never touch it with wet hand.
– Never rotate the heating part of the appliance during operation. To change
the tit angle of the heating part, we advise you to wait for 15 minutes after
the appliance has been switched off.
– Never place anything on your heater’s safety guard as this may cause
overheating (e.g. towels)
– Never use your appliance to dry washing.
– Although the heating element has stopped glowing, it may still be live and
potentially dangerous. Check that the selection indicator (5) is in position
off before taking any action.
– Switch off your appliance: a)After use, b) In the event of malfunction,
¢)Before cleaning it.
– Never operate your appliance if it has fallen over.
– Never dismantle your appliance. An incorrectly repaired appliance maybe
dangerous to the user. If you encounter any problems, please take it to one of
the Approved Service Centers in our customer service network. The warranty
will be void in the event of damage arising from improper use.
– Do not use this heater in the immediate surrounding of a bath, a shower or a
swimming pool.
– This movable appliance is designed for use in gardens, and can be used
indoor and outdoor. The warranty will not apply to appliances used for
professional usage. Although the heater may be used outdoors, the main plug
must only be connected to the supply indoors.
– The heater s provided with an anti-tilt switch will switch off the heater if
it is overturned, and will switch it on again automatically when it s restored
to its upright position.
– This appliance is not with a protective thermal for the temperature of room.
Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is
provided.
– This appliance is not intended for use by persons (including children) with
reduced physical, sensory or metal capabilities, or lack of experience and
knowledge, unless they have been given supervisions or instruction concerning
use of the appliance by a person responsible for the safety.
– Children should be supervised to ensure that they do not play with the
appliance.
VOLTAGE
Before using the appliance at the first time, ensure that your mains voltage corresponds to voltage indicated on the appliance. Itis a class appliance and must be earthed.
SAFETY
(CAUTION: Before fitting or removing the appliance, ensure that the heater’s
power line supplying the heater is disconnected. Check that the power line is
connected to a 30mA differential circuit breaker.
– This appliance is designed for use in gardens ,and any room in your house,
including those where there s a risk of splashing. The installation and use of
your appliance must comply with the applicable standards in your country.
– When itis switch on, an electrical heating appliance reaches very high
temperature libel to cause burns. Make sure that all other users are aware of
the risks.
– Ifyou have any doubts concerning installation possibilities for this heater,
please consult a qualified electrician.
– The appliance must be positioned so that the plug is accessible.
– Ifthe supply cord is damaged, it must be replaced by the manufacturer or its
service agent or similar qualified person in order to avoid a hazard
– The heater must not be located immediately below a socket-outlet
– Do not use this heater with a programmer, timer or any other device that
switches the heater on automatically, since a fire risk exists if the heater
is covered or positioned incorrectly.
– Do not place the appliance close to curtains and other combustible
materials.
HOW TO ASSEMBLE
– Before installing your appliance, you must disconnect the electrical supply
at the circuit breaker. Insert the lower post assembly (11) into the base
assembly (16) and then fix it tightly by means of 4-M6X30 screw, and insert
the clamp (12) into the lower post (11). (fig.1) Join the Lower Post Assembly
(1) and the Middle Post (9) together with 3-M5X6 screw. fig.2) Join the Upper
Post Assembly (7) and the Middle Post (9) together with 3-M5X6. screw. (fig.3)
Join the Heating Element Assembly (1) and the Upper Post Assembly (7) together
then fix them tightly by rotating the Knob, and put the power cord supply into
the camp.(fig.4)
According to the request of use angle, ~ Heating Element Assembly can adjust
angle at 00~45°Fig.5)
OPERATION
The appliance is switched on by means of the pull switch (5). The slight
vibration noticeable when the appliance is switched on will stop after a few
seconds.
OUTPUT
– Position 0: Stop
– Position 1: 650W (normal power)
– Position 2: 1300W (intermediate power)
– Position 3: 2000W (full power)
MAINTENANCE
Your appliance dose not requires any particular maintenance. However, in the event of a malfunction, please consult an approved service center.
PART DESCRIPTION
1. Heating Element Assembly
2. Knob
3. Body
4. Position Indication Plate
5. Pull Switch
6. Tube Cover
7. Upper Post Assembly
8. 3-M5X6 Screw| 9. Middle Post
10. 3-M5X6 Screw
11. Lower Post Assembly
12. (lamp
13. Power Cord
14. Base Cover
15. -M6X30 Screw
16. Base Assembly
---|---
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should nt be disposed with other
household wastes through out the EU.To prevent possible harm to the
environment o human health from uncontrolled waste disposal,recyce it
responsibly to promote the sustainable reuse of materialresources.Toreturn
your used device, please use the return and collection systems or ontac the
retailer where e product was purchased. They can take this product fo
environmental safe recycling.
IMPORTED IN EU BY EUROLAMP SA: KAMPOS DIAVATA – IONIA/ 570 08/
THESSALONIKI – GREECE /T: +30 2310 574802
MADE IN CHINA
info@eurolamp.gr
www.eurolampglobal.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>