EUROLAMP 147-29700-01 Quartz Heater with Remote Control Instruction Manual
- June 15, 2024
- EUROLAMP
Table of Contents
147-29700/ 147-29701
QUARTZ HEATER WITH REMOTE CONTROL
SYH-1207J
Watt: 2400W
Volt: 220V -240VAC
Hertz: 50-60Hz 
INSTRUCTION MANUAL
147-29700-01 Quartz Heater with Remote Control
This product is only suitable for well insulated spaces or occasional
use.
FORYOU OWN SAFETY READ ALL INSTRUCTIONS BEFORE USING QUARTZ HEATER.
- Make sure were using 220V -240VAC
- 0nly connect the Quartz heater toasingle-phase socket with a mains votage asspecified on the ratng plate.
- D0 ot leave your home while the applianceis n function, ensure that the switch s in OFF position and the thermostat isin minimur position. Always unplug the appliance.
- Keep combustible materialsuch as funiture, cushions,bedding, paper, lothes, curtains etc. ateast 100cm away from the quartz heater.
- Do not hang anything on orinfront of the quartz heater.
- Always unplug the heater when notinuse. Do not pull the cord to unplug the heater.
- Keep the airinlet and outletfree from objects at least in 1min front and S0cm behind the heater.
- Do ot ntallthe heater right below a socket.
- D0 not et animals orchldren touch or lay with the quartz heater, Pay atention to theair utlet ets hot during operation
- Do not covr. I covered, thereis therisk of overheating.
- Do not us this quartz heater in the immediate surrounding of bath, a showie. lose supervision s necessary when the heateris being used by or near children, prsons suffring from any physical impairment of pets.
- D0 not use the quartz heater in the rooms containing explosive gas nflammable solvents, varnish or glue.
- Ifthe power cord i damaged, do not plug the heater i, Consut your supplieror qualfied electican for replacing the damaged mains lead.
- Keep the quartz heater lean. Do not allow any objects to enter any ventilation o exhaust opening as this may cause electrc shack,orfire o damage to the heater.
- If the heater has been dropped or damaged it should not be used until a qualifed service centre has nspected it
- Close supervision is necessary when the heateri being used by or ear chidren, persons suffering from any physical impairment or pets
- D0 not e thisheater with a programmer, timer or any other devicethat switches the heater on automaticaly, since a ie ik exsts i the heater s covered or positioned incorrectly.
- This heater is notintended for se in bathrooms, laundry areas and similar indoor locations, never locate heater where it may fallnto a bathtub orother water container.
- To prevent a possible fire, do not lock airinakes orexhaust in any manner. Do not use on soft surfaces,lie a bed, where openings may become blocked.
COMPONENTS
OPERATION
First, please turn the main power switch on at the rear side, you will hear beep sound, and the display will light on.
OPERATION ON THE CONTROL PANEL
HEAT SETTING
Imagea.
ONE TIME HIGH HEAT [OH] all lamps turned on
HEAT SETTING
Image b.
TWO TIMES LOW HEAT [0L] lamps 1 and 2 turned on
ON/OFF BUTTON
Press the ON/OFF button to turn on the heater, the heater will be turned on at
the mode of high heat, the display will show room temperature.
TIMER SETTING
Under the timer mode, press*+”or ” to set up time within 24 hours, one press
will be 1 hour adjustment.
Setting timer at standby mode, it is reservation for turn on heater; Setting
timer at power on mode, it is reservation for turn off heater.
HEAT SETTING
Two settings. Press ONE TIME s high heatfall the lamps start working
1+2+3-+4image a) and it will ndicate “OH(2400W) in display panel. Press TWO
TIMES is low heat(lamps 1-+2 start working imageb), itwillndicate “0L(1200W)
in display. Press again and heating i off.
TEMPERATURE SETTING UNDER HEATING MODE
The temperature setting ranging from 16 to 30 degrees. Press this button, then
press“+” or“-” to increase or decrease the temperature, when the setting
temperature is lower than room temperature, the heater will stop to heat, when
the set temperature is higher than room temperature, the heater will heat
till the setting temperature.
TIME LIMIT
Itis 8 hours fixed timer. Press it, the time will be set into 8 hours.
WINDOW SENSOR
When the window s opened and the room temperature drops suddenly by 10
degrees,the heater will tun off automatically.
OPERATION ON REMOTE CONTROLLER
ON/OFF BUTTON
press the ON/OFF button to turn on the heater, the heater will be turned on at
the mode of high heat, the display will show Toom temperature.
TIMER
Under the time mode, press”+or“-“to set up time within 24 hours, one press
will be 1 hour adjustment. Setting timer at standby mode, it is reservation
for turn on heater; Set timer at power on mode, it is reservation for turn off
heater.
HEAT
Two settings. Press one time is high heat, it will indicate “OH” i display;
press two times s low heat, it will indicate “OL” in display; press again is
heating off.
TEMPERATURE SETTING UNDER HEATING MODE
The temperature setting ranging from 16 to 30 degrees. Press this button, then
press“+” o to increase or decrease the temperature, when the setting
temperature is lower than room temperature, the heater will stop to heat, when
the set temperature is higher than room temperature, the heater will heat
till the setting temperature.
WINDOW SENSOR
When the room temperature drops suddenly by 10 degrees,the heater will tum off
automatically.
SAFETY SYSTEM
Super quartz heater has a special safety system against ire. When the heater
istuned over or it by accdent, the safety system promptly cuts the electricity
offand the device does not work. On the other hand, the frame at the front sde
prevents any fir isk. There are other superioritiesof the system.
ATTENTION
Ifsupply cord becomes damaged it should be replaced only by authorized
personnel orservice departments of manufacturer otherwise you may be subject
to electricshock.
DO NOT COVER
WARNING: Inorder to avoid overheating, do not cover the heater The
instructions shallstate that the heater must not be located immediately below
a socket outet.
Do not use ths heater with a programme, timer o any other device that switches
the hearer on automaticallysincea firersk exsts of the heater s covered or
postioned or positioned incorretly.
Do not use this heater n the immediate surfoundings ofa bath, ashower or a
swimming pool.
CLEANING AND MAINTENANCE
Before deaning always remove theplug fiom the lectical socket.Cleanthe
arinlet/outlet rilesfrequentiy. Never use abrasive powders o sovents.
- This appliance is not intended for use by persons (including children) with recuced physical sensory or mental capabilties,orlack of experience and knowledge, nless they have been given supervision of instruction concerning use of the appliance by a prson responsible fo their safety.
- Children should be supervised to ensure that they not play with the appliance.
- In order o avoid any danger, the cable must be changed by the special person from the manufacturer service department or a elative department i the cable s damaged.
- The reflector body can be leaned with asoft damp doth, using a small quantity of neutral detergent, taking care not tosplash water on the lamps. Never use solutions such as benzene, hinnersor polishing agents.In order to gt the maximum heat,the eflector must b keep dlean.
- The main body of the heater can be ceaned with a soft damp coth, using a neutral soution. Aftr cleaning, wipe with adry coth.
- When the heater isnot in use, place in sealed plastic bag and store in ry place the heater can be packed again according to ts packing method.
You an help protect the envianment! Please remember to espect th local
vequlatons: hand in the non-working electical equipments to an appropriate
waste disposal centre
Used battries mustnot be disposed o through hausehald garbage sncethey
migh contin toxic elements and heavy metals that canbe harmful o the
envionment and human health.
Retun empty batterys to an appropiat recycing facility
INFORMATION REQUIRMENT FOR THE ELECTRIC LOCAL SPACE HEATERS
Model identifier(s): SYH-1207)
| ITEM | SYMBOL | VALUE | UNIT |
|---|
HEAT OUTPUT
Nominal heat output| Pnom| 2.4| kW
Minimum heat output (indicatise)| Pmin| 0.0| kW
Maximum continuous heat output| Pmax,c| 2.4| kW
Aux ilia ry electricity consumption| | |
At nominal heat| elmax| 0.0| kW
At minimum heat output| elmin| 0.0| kW
In standby mode| elSB| 0.0| kW
ITEM| UNIT
---|---
TYPE OF HEAT INPUT, FOR ELECTRIC STORAGE LOCAL SPACE HEATERS ONLY (SELECT
ONE)
manual heat charge control, with integrated thermostat| NO
manual heat charge control with room and/or outdoor temperature feedback| NO
electronic heat charge control with room and/or outdoor temperature feedback|
NO
fan assisted heat output| NO
TYPE OF HEAT OUTPUT/ROOM TEMPERATURE CONTROL (SELECT ONE)
single stage heat output and no room temperature control| NO
Two or more manual stages, no room temperature control| NO
with mechanic thermostat room temperature control| NO
with electronic room temperature control| NO
electronic room temperature control plus day timer| YES
electronic room temperature control plus week timer| NO
OTHER CONTROL OPTIONS (MULTIPLE SELECTIONS POSSIBLE)
room temperature control, with presence detection| NO
room temperature control, with open window detection| YES
with distance control option| NO
with adaptive start control| NO
with working time limitation| NO
with black bulb sensor| NO
Contact details: EUROLAMP SA
Kampos Diavata / lonia, P.O. 515 / 570 08, Thessaloniki – Greece
CUSTOMER SERVICE LINE(for service and spare parts)
+30 2310 574 802(dial 116)
Documents / Resources
|
EUROLAMP 147-29700-01 Quartz Heater with Remote
Control
[pdf] Instruction Manual
147-29700-01, 147-29700-01 Quartz Heater with Remote Control, 147-29700-01,
Quartz Heater with Remote Control, Heater with Remote Control, with Remote
Control, Remote Control, Control
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>