EUROLAMP 147-28250-251 Floor Fan 34cm 35W Instruction Manual
- June 13, 2024
- EUROLAMP
Table of Contents
STAND FAN
147-28250/147-28251
INSTRUCTIONS
READTHIS NANUALTHORQUGHLY BEFORE USNG
AND SAVE T FOR FUTUREREFERENCE
TECHNICAL CHARACTERISTICS
Vo :AC220-2400
~ S0Hz Wat: 33W
Please read these nstructions carefuly before connecting your device to the mains. Please pay particulr attention to the safety information. We recommend that you keep the instructions for future reference.
GENERAL DIRECTIONS
-
Remove the packaging and make sure that the appliance is intact. If in doubt, do not use it and contact qualified personnel only.
-
Packaging materials (plastic bags, polystyrene, staples etc.) must be kept out of the reach of children as they could be hazardous.
Caution:
~This appliance can be used by children aged from 8 years and above and people with reduced physical, sensory or ‘mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
-Children should be supervised to ensure that they do not play with the appliance.
-Cleaning and maintenance operations must not be performed by children without supervision -
Before connecting the appliance, check that the appliance rating corresponds to the mains rating.
-
This appliance must only be used for the purpose for which it has been manufactured, i.e. as a stand fan. The ‘manufacturer is not responsible for any damage caused by improper or incorrect use.
-
The installation/assembly of the device will be made according to the indications of the manufacturer.
A wrong procedure may cause damages to persons, animals or objects, for which the manufacturer cannot be considered responsible -
Before cleaning or carrying out maintenance on the appliance, disconnect it from the electrical mains by removing the plug from the electrical outlet or by switching off the system switch.
-
If the appliance is faulty and/or operating incorrectly, switch it off without tampering with it. If the above is disregarded, the safety of the appliance may be compromised.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified personsin order to avoid a hazard.
-
D0 NOT power the device using multiple sockets.
-
D0 NOT use adapters and/or extension cable
-
The device must not be switched on using external timers and/or other remote control devices which are not specified in this manual.
-
D0 NOT use or store the device near heat sources(heaters, stoves etc.).
-
D0 NOT dip the device in water or other liquids; in case the accidental fall in the water DO NOT try to take it out, but first of all unplug immediately the power cable from the socket.
-
If you use the device for the first time, make sure to remove any label or protective sheet which blocks its proper functioning.
-
Plug and unplug the power cable with dry hands and hold it firmly.
-
Before plugging make sure the start button of the device is in the “OFF” position (turned off).
-
Always unplug the power cable to avoid the overheating and avoid stretching it (do not pull it, tug it or use it to drag the device to which is connected).
-
Avoid placing the power cable on abrasive or sharp surfaces or in positions where it can be damaged easily.
-
D0 NOT obstruct totally nor partially the air vents or inserts objects inside.
-
D0 NOT hang the fan on the wall or ceiling unless this type of installation is provided and explained in this manual.
-
Place the device at a proper distance from the objects or surrounding walls making sure that its functioning will not cause accidental damages.
-
D0 NOT use the device near gas stoves or open flames in general.
-
D0 NOT use the device near curtains or textiles.
-
D0 NOT cover the device during functioning.
-
D0 NOT expose yourself for a long period to the air flow generated by the device because it can cause damage to the health.
-
If the fan must be stored for a long period and is not used reqularly, place the fan in its original packaging in a dry place.
-
Switch off the appliance and remove the plug from the electrical outlet or switch off the system switch when not inuse.
-
The use of any electrical appliance calls for the awareness of some basic rules, such as:
-do not touch the appliance with wet or damp hands or feet.
-do not leave the appliance exposed to atmospheric agents. -
Always remember to unplug the power cable of the device if it is not used for a long period, before storing,
cleaning or performing any maintenance operation. -
Max. ambient temperature 40°C.
-
Do not use the appliance in the presence of potentially flammable or explosive liquids or gases.
-
The appliance conforms with Directives 2014/30/EU regarding Electromagnetic Compatibility (EMC) and
Directives 2014/35/EU regarding Low Voltage (LVD). -
This product is intended for household use ONLY and not for commercial / industrial or outdoor use.
-
Cleaning and user maintenance shall not be made by children without supervision
-
The supply terminals are not to be short-circuited.
The symbol on the product means that at the end of it life, the appliance must not be considered normal waste but hazardous waste and, as such, must be disposed of in specific recovery and disposal areas, as prescribed by the Directive 2012/19/EU on electrcal and electronic waste equipment (WEEE). By disposing ofthis product corectly, you can prevent negative consequences for the environment and for human health, due to the presence of potentially I hazardous substances in the product.
APPLIANCE COMPONENTS
| 1. Grid | 8. 0SCswitch |
|---|---|
| 2.Blades | 9. Motor |
| 3. Upper tube | 10.Tilt angle screw |
| 4. Control box | 11. Power cord |
| 5. Height adjustment ring | 12.Base |
| 6. Lower tube | 13. Foot |
| 7. Decoration ring | 14. Weight of the base |
ASSEMBLY
Unpack the fan and make sure all the parts are available before proceed with the installation.
- Place the weight of the base under the base and insert the lower tube through the holes of them. Fix the parts together by using the screw provided.
- Loose the outer locker and pull out the upper tube from lower tube with the height which you want and lock the tube
- Fix the head of the fan to the upper tube by using the screw provided.
- Fix the control box on the tube with the screw and rubber pad we provide.
- Control box have two option for upper tube and lower tube,, please don’t use wrong notch.
The fan can be installed at two heights depending on using control box and
pulling up tube.
ATTENTION : do not connect the fan to electrical supply until the unit is
fully assembled.
HOW TO USE
Place the fan in a flat and stable surface. Make sure the Off/Speed knob is in
Off position (“0”) then plug it into a correct socket. To select the desired
speed it’s enough rotate the Off/Speed knob.
0=off
|’=minimum speed
|| = medium speed
||| = maximum speed
Caution: when the fan is not used disconnect it from the electrical
supply.
MAINTENANCE
Before carrying out the reqular cleaning operations turn the fan off and
unplug it. For external cleaning use a soft and dry cloth.
DO NOT disassemble the fan: this fan cannot be disassembled.
DO NOT dip the device in water, or splash it with any other liquids.
DO NOT use solvents or any other chemical products for cleaning it.
Pack the fan in the original box and place itin a dry, well-ventilated place
when it is not to be used for a long period of time.
CORRECT DISPOSAL OF THIS PRODUCT This marking indicates that this product
should not be disposed with other household wastes throughout the EU.
To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly t promote the sustainable reuse of
material resources.
To return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
• IMPORTED IN EU BY EUROLAMP SA:
KAMPOS DIAVATA – IONIA / 570 08 /THESSALONIKI
– GREECE IT: +30 2310574802 • MADE IN CHINA
info@eurolamp.gr
www.eurolampglobal.com
CUSTOMER SERVICE LINE
(for service and spare parts)
+30 2310 574 802(dial 116)
Documents / Resources
|
EUROLAMP 147-28250-251 Floor Fan 34cm
35W
[pdf] Instruction Manual
147-28250-251 Floor Fan 34cm 35W, 147-28250-251, Floor Fan 34cm 35W, Fan 34cm
35W
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>