VIDEX VLE-F3-0305B LED F3 Spotlight User Manual

June 14, 2024
VIDEX

VIDEX VLE-F3-0305B LED F3 Spotlight

TECHNICAL PARAMETERS

VIDEX-VLE-F3-0305B-LED-F3-Spotlight-fig-1VIDEX-
VLE-F3-0305B-LED-F3-Spotlight-fig-2VIDEX-
VLE-F3-0305B-LED-F3-Spotlight-fig-3

  1. Rated power (W)

  2. Rated full luminous flux Lm (Lm)

  3. Rated useful luminous flux measured in a 120° cone (use)

  4. Class of energy efficiency in accordance with the Regulation of the European Commission 2019/2020

  5. Class of energy efficiency in accordance with the technical regulations of Ukraine
    INTERPRETATION OF THE ICONS

  6. Correlated color temperature (K).

  7. The product has an integrated motion sensor

  8. The product is not compatible with light dimmers

  9. Color rendering index

  10. Nominal lifetime L, B.. (hours)

  11. Rated beam angle

  12. Class of protection against dust and moisture. The product is protected from dust and water jets

  13. On/off cycles:

  14. Class of protection against mechanical impacts

  15. Time to reach 100% light flux (sec.)

  16. No mercury contains

  17. Minimum distance from the illuminated object

  18. Caution, risk of electric shock

  19. The product can be installed and used on normally flammable surfaces

  20. Protection against electric shock class I.

  21. A product in which the means of protection against electric shock, in addition to the main insulation is an additional protective circuit connected to the grounding of the power supply network

  22. Product compliable with standards of ecodesign and energy labeling according to Commission Regulation (Eu) 2019/2020

  23. For outdoor use

  24. The product is suitable for use in industrial premises

  25. The built-in light source is non-replaceable

  26. Do not use the product with a damaged light diffuser. A damaged light diffuser must be replaced

  27. The product complies with the technical regulations of Ukraine

  28. The product meets the requirements of EU directives:

ENVIRONMENTAL PROTECTION

Pursuant to the provisions of the WEEE Act, it is forbidden to put waste equipment marked with the symbol of a crossed bin together with other waste. The user, wishing to get rid of electronic and electrical
equipment, is obliged to return it to a waste equipment collection point. There are no hazardous components in the equipment that have a particularly negative impact on the environment and human health.

  • Overall dimensions (mm)., product weight (g/kg), rated input voltage (V) and frequency (Hz), rated current (mA), operating temperatures range (*C), production date and batch number are indicated on individual packaging:
    • Light power curve type: sine (C).
    • The product contains no harmful substances.
    • Product materials: aluminum alloy, polycarbonate;
    • The shelf life before the start of use is unlimited;

PRODUCT’S PURPOSE AND APPLICATION
The product is intended for lighting open spaces, architecture, and industrial objects. Not intended for use in domestic premises.

not included

VIDEX-VLE-F3-0305B-LED-F3-Spotlight-fig-4

Available only for models with motion sensor

CONTENTS OF THE KIT

VIDEX-VLE-F3-0305B-LED-F3-Spotlight-fig-7

  • Floodlight
  • Mounting bracket
  • User’s manual
  • Individual packaging

MOUNTING AND CONNECTION INSTRUCTIONS

Before installation, it is necessary to read the instructions. Installation must be performed by a specialist with appropriate qualifications. Installation and connection can only be carried out when the power supply is switched off. Please install and connect according to the scheme below. The connection must be made using a screw terminal block. The product has a grounding wire. Failure to connect the grounding wire may result in possible electric shock. Before the first use, it is necessary to check the correctness of the mechanical fastening and connection. The product can only be used in a network that meets the energy requirements and quality standards stipulated by law.

FUNCTIONAL CHARACTERISTICS

The product can be used either indoors (only on industrial premises) or outdoors.

MAINTENANCE AND SAFETY INSTRUCTIONS
WARNING! Do not look directly at the LED beam. The product can heat up to high temperatures. Do not touch; there is a risk of burns. Any maintenance works should be carried out with the electricity switched off and the product should be cooled and dry. Do not cover the radiator of the floodlight, ensure free air access. Clean only with soft and dry clothes. Do not use chemical detergents. The product may only be supplied with rated voltage or voltage within the given range. It is forbidden to use the product with a damaged light diffuser, damaged wiring, or connection points.

Do not attempt to repair or disassemble the sealed housing of the floodlight, as this may impair its performance and void the warranty. The product cannot be used in adverse conditions, e.g. vibration, explosive atmosphere, fumes or chemical fumes, etc. The product has an irreplaceable LED light source. In case of damage to the light source, the product cannot be repaired. A used or damaged product should be disposed of in accordance with current regulations. Failure to follow these instructions may result in e.g. fire, or burns. electrical shock, physical injury, and other material and non-material damage. The producer shall not be responsible for any damage resulting from the failure to follow the above instructions.

STORAGE AND TRANSPORTATION
Before delivery to the direct point of sale, the product must be stored in the manufacturer’s packaging at a temperature from -20°C to +40°C, in a dry room and without exposure to direct sunlight. Transportation can be carried out by land, sea, and air transport in the manufacturer’s transport packaging.

WARRANTY

The warranty period for the product is indicated on the individual packaging and begins from the date of sale. During the warranty period, a faulty product can be exchanged or returned with prove of purchase and all components and accessories preserved. The following does not apply with the scope of limited warranty:

  • Misuse the product and cause the product components to damage
  • Unauthorized disassemble or the presence of deep mechanical damage to the product
  • Damage due to force majeure.
  • The manufacturer reserves the right to make changes to these user manual or technical changes to the product without prior notice.

Importer: Allegro Opt Sp. z 0.0., Handlowa 23, 05-120 Legionowo, Polska.
Made in China/Wlyprodukowano  Chinach. www.videx.com.pl
Allegro-opt PE, 106-G Heroiv Mariupolia street, Kropyvnytskyi, 25004, Ukraine

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals