ROADSAFE SB065 Headlight Level Extension Bracket Instruction Manual
- June 13, 2024
- ROADSAFE
Table of Contents
FITTING INSTRUCTIONS
SB065 Headlight Level Extension Bracket
TOOLS REQUIRED
General hand tools
VEHICLE :Nissan Navara NP300
PRODUCT :Headlight Level Extension Bracket
PART NUMBER : SB065
The Nissan Navara headlight extension bracket is designed to correct the ratio
of travel for lifted vehicles to correct headlight adjustment & minimise the
potential of damaging the original system.
The heights marked on the bracket are a guide relating to the vehicle’s
suspension lift and are for reference only.
Throughout the fitment process, you may need to move the OE linkage to a
higher or lower setting to ensure the least amount of stress is applied to the
factory components. The goal is to prevent any bind or overextending which
could result in a component failure.
- Remove linkage and original bracket from axle housing. See figure 1.
- Fit bracket with existing and supplied M8 bolts.
- Loosen M8 bolt on handbrake cable retainer.
- Slide gusset bracket into location.
- Fit supplied M6 bolt and nut through both brackets and tighten all hardware. See figure 2.
- Fit leveling linkage into bracket in appropriate numbered location.
- Cycle through full suspension travel to ensure the linkage and bracket don’t foul or have any excess stress. See figure 3.
A division of Specialist Wholesalers Pty. Ltd. ABN 64 163 280 279
VIC PH: 03 8687 1700 | QLD PH: 07 3737 7420
Email:sales@roadsafe.com.au
roadsafe.com.au
Documents / Resources
|
ROADSAFE SB065 Headlight Level Extension
Bracket
[pdf] Instruction Manual
SB065 Headlight Level Extension Bracket, SB065, Headlight Level Extension
Bracket, Level Extension Bracket, Extension Bracket, Bracket
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>