ROADSAFE Toyota Prado 150 Series Recovery Tow Points Installation Guide

ROADSAFE Toyota Prado 150 Series Recovery Tow Points

Fitted to 150 Series Prado — with NO BULL BAR

1. Each side uses 3 x M12x1.25mm (inserted from the outside of the chassis rail – if the bolt holes to the chassis or bull bar are available). High-tensile bolts supplied, with relevant flat & split washer. At minimum, this tow point requires two bolts on each side.
2. Installation requires three nuts on wires (supplied) to be installed into the chassis rail for each tow point. This will require the bumper/bull bar to be removed on some models, Check your chassis before fitment.
3. The supply of a third bolt for each side is currently in transition—if your kit has only been supplied with a total of four bolts, it is recommended that a third bolt be fitted to each tow point if the bolt hole to the chassis or bull bar is available. You will need to purchase this bolt/nut set yourself , as it is not supplied in the kit during this transition period.
4. Ensure two bolts per tow point are fitted and torqued to recommended settings to ensure tow points meet tested standards.

Fitted to 150 Series Prado — with TJM Steel Bar

Please consult image 1 to determine bolt fitment locations.

At minimum, this tow point requires two bolts on each side.

150 Series Prado — TJM T13 Outback Bar

Please consult image 1 to determine bolt fitment locations (as per TJM Steel Bar).

At minimum, this tow point requires two bolts on each side.

Fitted to FJ Series Landcruiser

Please consult image 1 to determine bolt fitment locations.

At minimum, this tow point requires two bolts on each side.

Bolt Torque Specs

| 8.8| 10.9| 12.9
---|---|---|---
M10| 41-60 Nm| 59-85 Nm| 65-94 Nm
M12| 71-105 Nm| 102-150 Nm| 114-164 Nm
M14| 112-168 Nm| 161-240 Nm| 182-265 Nm
M16| 175-260 Nm| 250-371 Nm| 282-406 Nm

Ensure all supplied and specified components are used during the installation of tow points. Failure to do so will significantly reduce the Working Load Limit (WLL) specified for each individual point, which can result in serious injury or death.

IMPORTANT NOTE
Always use tow points as a matched pair teamed with an equalising bridle during any recovery situation.

Hardware supplied

• 6 x M12x1.25mm bolts
• 6 x M12x1.25mm nuts on wires
• 6 x flat washers
• 6 x split washers
  

Installation Instructions

CUSTOMERS SUPPORT

roadsafe.com.au

Roadsafe – A Division of Specialist Wholesalers Pty. Ltd. ABN 64 163 280 279 roadsafe.com.au VIC Phone: 03 8687 1700 QLD Phone: 07 3737 7420 Email sales@roadsafe.com.au

RECOMMENDED FOR 4WD SPECIALIST MECHANICS TO FIT. MANUFACTURERS’ NAMES ARE USED FOR REFERENCE PURPOSES ONLY.

References

• roadsafe.com.au

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>