mitzi H114701A Bella Pendant Light Instruction Manual
- June 12, 2024
- mitzi
Table of Contents
H114701A, H114701B, H114701C,
H114701D BELLA PENDANT
**Instruction Manual
**
GENERAL
- WARNING-DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE LIGHTING FIXTURE IS ATTACHED
- INSTALLATION AND MAINTENANCE OF THIS FIXTURE SHOULD BE COMPLETED BY A LICENSED ELECTRICAN
- FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH
- READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION.
- IF AN EXISTING FIXTURE IS BEING REPLACED, REMOVE IT AND NOTE TO WHICH WIRE IN THE OUTLET BOX THE ORIGINAL FIXTURE WAS ATTACHED.
- BEFORE DISCARDING THE CARTON DOUBLE CHECK THE PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN FOUND.
- THIS FIXTURE WAS DESIGNED TO BE MOUNTED TO AN OCTAGON OUTLET BOX. THE BOX MUST BE SECURELY MOUNTED TO THE STRUCTURE OF THE BUILDING.
INSTALLATION
STEP 1. Feed the wires through the spun trumpet, screw collar, canopy, and
nipple until you desired hanging height is met.
STEP 2. Tie an overhand knot to secure wire in place above the nipple, and
trim off excess wire to min 6” beyond the knot. Strip each wire end 5/8”
STEP 3. Attach the mounting plate to the outlet box using the mounting screws.
STEP 4. Fasten bare ground wire to ground wire from the wall outlet box
(usually green or copper color) or connect ground wire to green screw on the
mounting plate.
STEP 5. Connect the neutral (white) fixture wire coming from the fixture base
to neutral (usually white) outlet wire. Fasten both wires together with a
plastic wire nut and tightly wrap the wire nut with electrical tape.
STEP 6. Repeat the previous step with the hot (black wires). Make sure there
are no exposed wires or strands that couldcause a dangerous short circuit.
FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SERIOUS
INJURY OR DEATH!
STEP 7.Carefully place wires into Outlet Box.
STEP 8.Place the canopy with the fixture over the outlet box and fasten it by
the screw collar.
STEP 9.Install the lamp(s). The fixture is rated for 60 watt A19 lamp.
STEP 10.DO NOT EXCEED RECOMMENDED WATTAGE! STEP 11.Lift up the spun trumpet
and glass. Secure glass with the thumb screws and move spun trumpet down over
the glass.
STEP 11. Restore power to the circuit at breaker or fusebox.
DIMMING
The fixture can be controlled by a wall dimming device. Only use triac/electronic dimmer. Make sure carton is marked for use with LED compact fluorescent-incandescent light source only. These can beprovided by your local electrical distributor, home center, or hardware store.
CLEANING
please clean with a soft, dry cloth ONLY! Do not use cleaning products.
ASSEMBLY AND MOUNTING DIAGRAM
WIRE NUT/TAPING DIAGRAM
www.hudsonvalleylighting.com/mitzi
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>