mitzi H125701S ELLA Pendant Light Instruction Manual

: June 12, 2024
: mitzi

Table of Contents

ASSEMBLY AND MOUNTING INSTRUCTIONS
ASSEMBLY AND MOUNTING DIAGRAM
WIRE NUT/TAPING DIAGRAM
CUSTOMER SUPPORT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

mitzi H125701S ELLA Pendant Light

ASSEMBLY AND MOUNTING INSTRUCTIONS

GENERAL

WARNING-DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE LIGHTING FIXTURE IS ATTACHED
INSTALLATION AND MAINTENANCE OF THIS FIXTURE SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN
FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH
READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION.
IF AN EXISTING FIXTURE IS BEING REPLACED, REMOVE IT AND NOTE TO WHICH WIRE IN THE OUTLET BOX THE ORIGINAL FIXTURE WAS ATTACHED.
BEFORE DISCARDING THE CARTON DOUBLE CHECK THE PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN FOUND.
THIS FIXTURE WAS DESIGNED TO BE MOUNTED TO AN OCTAGON OUTLET BOX. THE BOX MUST BE SECURELY MOUNTED TO THE STRUCTURE OF THE BUILDING.

INSTALLATION

STEP 1. Feed the cord through the screw collar, canopy, nipple, and mounting plate until you desired hanging height is met.
STEP 2. Tie an overhand knot to secure wire in place above the nipple, and trim off excess wire to min 6” beyond the knot. Strip each wire end 5/8”
STEP 3. Attach the mounting plate to the outlet box using the mounting screws.
STEP 4. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
STEP 5. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
STEP 6. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH!
STEP 7. Carefully place wires into Outlet Box.
STEP 8. Place the canopy with the fixture over the outlet box and fasten it by the screw collar.
STEP 9 Install the lamp. The fixture is rated for 60 watt A lamp.
DO NOT EXCEED RECOMMENDED WATTAGE!
STEP 10. Unscrew the lock ring and slide the glass cover up.
STEP 11. Hold the glass ball with the hole on upside and tilt the glass ball to a certain degree, then the glass bracket can go into the glass and hang it stable.
STEP 12 Slide down the glass cover to the glass ball and screw the lock ring onto the glass bracket to keep the glass cover and glass ball secure.
STEP 13. Restore power to the circuit at breaker or fuse box.

DIMMING

The fixture can be controlled by a wall dimming device. Only use triac/electronic dimmer. Make sure carton is marked for use with LED compact fluorescent-incandescent light source only. These can be provided by your local electrical distributor, home center, or hardware store.