MARIMEX 10622005 Universal Suspension Skimmer Instruction Manual
- June 5, 2024
- MARIMEX
Table of Contents
MARIMEX 10622005 Universal Suspension Skimmer
Package Contents
- Pool hook with inflatable lime
- Skimmer holder
- Adjustable bar
- Float
- Skimmer basket
- Skimmer basket
- Flap
- Skimmer body
- Adapter
- Hose
- Clamp
- Screw
- Washer
- Fixed frame pool hook
- Adapter
- Gasket
Safety instructions
Important safety regulations. Read and follow all these safety guidelines.
WARNING: To prevent accidents, disable any manipulation of this product
with children. Only adults may install and disassemble this product.
RECOMMENDATION: Before covering the pool with a tarpaulin, please remove
the product from the pool. Please check all components before use. When
storing the product, store it in a dry place indoors.
Mounting instructions
- Assemble the holder first – according to the pool type:
- a. For pools with inflatable collars, use Parts 1, 2, 3, Figure 1.
- b. For fixed frame pools, use Parts 2,3,14 – Attach the washer and screw 12,14, Fig. 1A to the hook 2.
- Attach the hose 10 (clipped hose section) to the skimmer body, figure 2.
- Attach the skimmer hose to the wall, use the appropriate adapter 9 or 15, figure 3.
- Connect the whole bracket assembly to the skimmer, Figure 4.
- It is necessary to hold the clamp 11 when the holder is inserted, figure 5. The skimmer must be immersed in water 2-3 cm. You can adjust the height by press-ing the clamp and sliding the bracket.
- Insert a skimmer basket and float into the skimmer body, Figure 6. The float must swim above the skimmer at a distance of 2.5 cm to 12.7 cm. The skimmer surface must always be in vertical position so that the top of the float is parallel to the water surface and the skimmer can collect the dirt well.
- Filter the filter device according to the user manual for filtering, figure 7. Turn on or plug into a power socket. If water does not flow into the filter device, make sure the skimmer is perpendicular to the water surface and immersed under wa-ter. Open the air filter valve as soon as the water starts to flow, close the valve. Never let the filter device run idle. The engine may overheat and damage may occur.
Warranty conditions
The skimmer was made of the highest quality materials and high quality finish.
All parts have been inspected and found to be unsafe. The warranty is valid
for two years from the date of purchase. Keep all purchase documents together
with the instructions. Proof of purchase will be required when applying
warranty claims.
Complaints of goods are governed by the Czech legal order. The warranty covers
all defects caused by manufacturing faults or material defects affecting the
functionality of the skimmer.
After purchasing the skimmer, we recommend checking the integrity of the
shipping container and skimmer or other degradation. In the case of any damage
the dealer immediately. We recommend that you review its completeness when
purchasing the product.
If the skimmer shows obvious defects that occur immediately after
commissioning and for which the skimmer can not be used, the buyer must apply
defects to the seller without undue delay. If a fault is detected on the
individual parts of the skim-mer, complain only that the defective part with
the visible location of the damage is damaged. The warranty does not apply to
wear due to improper installation or incorrect use, improper handling, wear
and tear of equipment corresponding to the nature and time of its use, defects
caused by mechanical damage, defects caused by natural forces, defects caused
by the use of non-standard means for chemical maintenance of pool water and
inappropriate cleaning aids, use of non-original parts, unauthorized
interference skimmer or its damage. Print errors are reserved 
Contact
www.marimex.cz
Custome Centre
tel.: 261 222 111
e-mail: [email protected]
References
- Marimex.cz - specialista na bazény, trampolíny a infrasauny | Marimex.cz
- Marimex.sk - špecialista na bazény, trampolíny a infrasauny | Marimex.sk