mitzi H125101 Ella Wall Sconce Instruction Manual
- June 12, 2024
- mitzi
Table of Contents
- mitzi H125101 Ella Wall Sconce Instruction Manual
- ASSEMBLY AND MOUNTING INSTRUCTIONS
- GENERAL
- FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT IN SERIOUS INJURY OR
- INSTALLATION
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
mitzi H125101 Ella Wall Sconce Instruction Manual
ASSEMBLY AND MOUNTING INSTRUCTIONS
GENERAL
- WARNING-DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE LIGHTING FIXTURE IS ATTACHED
- INSTALLATION AND MAINTENANCE OF THIS FIXTURE SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN
FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT IN SERIOUS INJURY OR
DEATH
-
READ ALL INSTRUCTIONS BEFORE STARTING
-
IF AN EXISTING FIXTURE IS BEING REPLACED, REMOVE IT AND NOTE TO WHICH WIRE IN THE OUTLET BOX THE ORIGINAL FIXTURE WAS
-
BEFORE DISCARDING THE CARTON DOUBLE CHECK THE PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN
-
THIS FIXTURE WAS DESIGNED TO BE MOUNTED TO AN OCTAGON OUTLET BOX. THE BOX MUST BE SECURELY MOUNTED TO THE STRUCTURE OF THE
INSTALLATION
STEP 1. Pull the wires out from the outlet box, and install mounting
plate onto the outlet box using the (2) mounting screws.
STEP 2. Fasten bare ground wire to ground wire from the wall outlet box
(usually green or copper color) or connect ground wire to green screw on the
mounting plate.
STEP 3. Connect the neutral (white) fixture wire coming from the
fixture base to neutral (usually white) outlet wire. Fasten both wires
together with a plastic wire nut and tightly wrap the wire nut with electrical
tape.
STEP 4. Repeat the previous step with the hot (black wires).
Make sure there are no exposed wires or strands that could cause a dangerous
short circuit.
CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH!
STEP 5. Carefully place connections back into the outlet box
STEP 6. Place Back plate over the mounting plate and secure with set
screws. STEP 7
STEP 8. Unscrew the ring to release the glass fitter. Install the
lamp. The fixture is rated for 60 watt type A lamp.
STEP 9. Tilt and rotate the glass shade so that the glass holder rest
into the glass shade .Drop glass fitter and secure with the ring.
STEP 10. Restore power to the circuit at breaker or fuse box.
DIMMING
**** The fixture can be controlled by a wall dimming device. Only use
triac/electronic dimmer. Make sure carton is marked for use with LED compact
fluorescent-incandescent light source only. These can be
provided by your local electrical distributor, home center, or hardware store.
CLEANING
Please clean with a soft, dry cloth ONLY! Do not use cleaning products
ASSEMBLY AND MOUNTING DIAGRAM
WIRE NUT/TAPING DIAGRAM
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>